Manual Olsberg Palena Plus SD Compact (page 14 of 36) (English, German, Dutch, French)

744282

Zoom out

Zoom in

1/36

14

Regulations to be observed

●

Local and building law regulations

●

The stove must be installed by a professional and

connected to the chimney. The specific national

regulations for safe installation of the connector

must be complied with. The connecting piece

used must possess an opening for cleaning.

●

The stove must be regularly checked by a profes-

sional.

●

The stove has national technical approval from the

Deutsches Institut für Bautechnik (DIBt) (German

Institute for Civil Engineering) for room-air inde-

pendent operation.

Due to its general technical approval, the stove

can be used simultaneously with an approved

ventilation sys- tem without additional safety

device.

Equipped with a self-closing combustion chamber

door, the stove is approved to be connected to multi-

flue chimneys provided that it operates with a room-

air dependent combustion-air supply.

Room-air independent operation requires that the ex-

haust gases of the fireplace be discharged through a

single-flue chimney or the exhaust duct of a single-

flue air-exhaust chimney. Exhaust gases may also be

discharged into multi- flue exhaust gas systems if all

connected fireplaces are part of the same utilisation

unit/action range of the ventilation system. Individual

differences can be discussed with your district master

chimney sweep.

Chimney design

The chimney design is according to DIN EN 13384 -

1 and - 2 or to the specific national regulations.

The chimney must comply with the temperature

class T400.

Necessary data

Closed operation

with billet wood / wood briquettes:

●

Nominal thermal output ............................. 5,0 / 5,0 kW

●

Waste air mass flow rate ............................. 4,5 / 5,6 g/s

●

Waste air temperature at

connection duct ..........................................

330 / 320 °C

●

Minimum delivery pressure at

nominal thermal output. ................................ 12 / 12 Pa

Combustion air supply

The stove can be operated conventionally, dependent

on the ambient air as well as independent of the am-

bient air. It must be guaranteed that there is enough

combustion air available for the stove. For the proper

function of the stove, a necessary combustion air vol-

ume current of 18,7 m³/h must be considered.

Ambient air independ-

ent combustion air

connection

By an ambient air independent operating mode, the

com- bustion air must be added from outside

through a leak- proof line or through a supply duct

in the chimney. Thus, speak with your district chim-

ney sweep master.

Due to energy saving reasons, the combustion air

inlet should be able to be blocked if the stove is not

being operated. This can occur through a shut-off

valve in the combustion air line or through the air

slide valves on the stove. If a shut-off valve is used,

this must be clearly identified with CLOSED/OPEN.

Through the shutoff, it is avoided that heat is removed

from the set-up room through the constant circulation

of cold combustion air and cold combustion air lines

may lead to an increased formation of condensation.

Attention:

The combustion air line may not be closed

during operation!

In order to feed the combustion air to the stove exter-

nally via a pipe instead of from the room in which it is

installed, it is possible to screw a Ø 125 mm combus-

tion air pipe to the back of the stove or at the bottom.

If the combustion air pipe installed is longer than 3 m,

calculations will have to be carried out to verify an ad-

equate supply of combustion air. At extremely low

outdoor temperatures, condensation can occur on the

combustion air duct. For this reason it must be insu-

lated with a suitable insulating materi- al. Observe the

rules of the oven and air heating construction craft.

Use the Olsberg combustion air pipes with sealing lip.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg Palena Plus SD Compact in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,03 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Olsberg Palena Plus SD Compact Manual

Product: