Manual Olsberg Pacaya plus Compact (page 16 of 52) (English, German, Dutch, French, Spanish)

744281

Zoom out

Zoom in

1/52

Regulations to be observed

● Local and building law regulations

● The stove must be installed by a professional and con-

nected to the chimney. The specic national regulations

for safe installation of the connector must be complied

with. The connecting piece used must possess an open-

ing for cleaning.

● The stove must be regularly checked by a professional.

● The stove has national technical approval from the

Deutsches Institut für Bautechnik (DIBt) (German

Institute for Civil Engineering) for room-air independ-

ent operation.

Due to its general technical approval, the stove can be

used simultaneously with an approved ventilation sys-

tem without additional safety device.

The heating stove’s re door is self-closing; it is there-

fore approved for connection to chimneys with multiple

connections.

For combustion air inlet which is independent of the am-

bient air, an easy adaptation of the chimney needs to be

made. Individual dierences can be discussed with your

district master chimney sweep.

Chimney design

The chimney design is according to DIN EN 13384 -1 and

-2 or to the specic national regulations.

The chimney must comply with the temperature class

T400.

Necessary data

Closed operation

with billet wood / wood briquettes:

● Nominal thermal output ......................................6,2 / 6,2 kW

● Waste air mass ow rate ....................................... 5,8 / 6,8 g/s

● Waste air temperature at

connection duct .....................................................336 / 315 °C

● Minimum delivery pressure at

nominal thermal output ...........................................12 / 12 Pa

Combustion air supply

The stove can be operated conventionally, dependent on

the ambient air as well as independent of the ambient air.

It must be guaranteed that there is enough combustion air

available for the stove. For the proper function of the stove,

a necessary combustion air volume current of 15,6m³/h

must be considered.

Ambient air independent

combustion air connection

By an ambient air independent operating mode, the com-

bustion air must be added from outside through a leak-

proof line or through a supply duct in the chimney. Thus,

speak with your district chimney sweep master.

Due to energy saving reasons, the combustion air inlet

should be able to be blocked if the stove is not being op-

erated. This can occur through a shut-o valve in the com-

bustion air line or through the air slide valves on the stove.

If a shut-o valve is used, this must be clearly identied

with CLOSED/OPEN.

Through the shuto, it is avoided that heat is removed

from the set-up room through the constant circulation of

cold combustion air and cold combustion air lines may

lead to an increased formation of condensation.

Attention:

The combustion air line may not be closed during

operation!

In order to feed the combustion air to the stove externally

via a pipe instead of from the room in which it is installed,

it is possible to screw a Ø 125 mm combustion air pipe to

the back of the stove or at the bottom. If the combustion

air pipe installed is longer than 3 m, calculations will have

to be carried out to verify an adequate supply of combus-

tion air. At extremely low outdoor temperatures, conden-

sation can occur on the combustion air duct. For this rea-

son it must be insulated with a suitable insulating materi-

al. Observe the rules of the oven and air heating construc-

tion craft.

Use the Olsberg combustion air pipes with sealing lip.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg Pacaya plus Compact in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Olsberg Pacaya plus Compact Manual

Product: