707621

Olsberg Draco Manual

13
Zoom out
Zoom in
Previous page
1/32
Next page
13
Operation
Permissible fuels
The following fuels are approved:
● Natural shopped wood in the form of billet wood
Maximum length: .....................33 cm
Circumference: .......... approx. 30 cm
● Wood briquettes to DIN EN 14691
Size class HP 2
Maximum length: .....................20 cm
Billet wood reaches a moisture content of 10 to 15% after
being stored outdoors for 2 to 3 years (only covered at the
top) and is then ideally suited for heating.
Freshly cut wood has a very high moisture content and
so burns badly. Apart from the very low caloric value it is
also harmful for the environment. The increased conden-
sate and tar formation can lead to replace and chimney
sooting.
This diagram shows that the consumption rate with fresh-
ly-felled wood (caloric value 2.3 kWh/kg) is almost twice
as high as the consumption rate with dry wood (caloric
value 4.3 kWh/kg).
Moisture [%]
dry wood that has been stored for at least 2 years
Caloric value [kWh/kg]
freshly-felled wood
You will only achieve optimum combustion and heat in
an environmentally friendly way with these fuels. Adding
the fuel in small quantities avoids unnecessary emissions.
Clean burning can be identied by the fact that the re-
brick becomes a light colour.
According to the German Federal Immission Control Act,
it is forbidden e.g. to burn the following fuels in stoves:
● Moist wood or wood treated with wood
preservatives
● Sawdust, chippings, grinding dust
● Bark and chipboard waste
● Slack coal
● Other wastes
● Paper and cardboard (except for igniting)
● Straw
Please note before heating for the rst time
● Remove all accessories from the ash pan and combus-
tion chamber.
● The odour given o by the evaporation of the protec-
tive coating disappears after the stove has been burn-
ing for several hours (ventilate the room well).
● The stove has a high quality temperature resistant coat,
which does not achieve its nal strength until the stove
has been heated for the rst time. You should therefore
never leave anything on the stove and not touch the
surfaces as the paint coat could otherwise be damaged.
● As soon as the kindling material has burned down, put
on 2 burnouts consisting of 3 kg wood ensuring that the
temperature resistant coating reaches its nal rmness.
Igniting
● Before ignition, check that no ammable objects are
placed on the stove.
● Empty the ash pan if necessary and slide back in.
● Open the combustion air slide valve complete.
● Grate in open position = operating lever pulled out
● Stack small amounts of rewood and, on top of it, kin-
dling material (igniter cubes and dry, smaller kindling)
and set the material alight.
● Close the door to the combustion chamber so that the
kindling material can catch re.
● Once there is a basic rebed, add more fuel according to
the heat requirement (see chapter “Heating”).
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olsberg Draco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg Draco in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info