776120
101
Zoom out
Zoom in
Previous page
1/116
Next page
101
UNICO - STAR
GB
4
TROUBLESHOOTING
In case of faulty system operation, refer to the following table.
If, after making the suggested inspections and controls, the problem has not been remedied, contact the authorised after-sales service.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Verify if there is voltage in the mains (turn on a light,
for instance).
Make sure the master switch is closed or that a
fuse is not burned (replace, if needed). If a
thermomagnetic switch is installed instead of the
master switch, verify that the former has not tripped
(if it has tripped, it must be reset).
If the problem persists, contact the After-Sales
Service immediately, and avoid trying to make the
unit operate.
If the batteries are discharged, the display will not
show any information, and no confirmation acoustic
signal will be heard when transmitting whatever
command to the unit. In this case replace the
batteries.
Verify and possibly correct the temperature setting
on the remote control.
Check it and clean it if necessary.
Remove anything which could obstruct the air flows.
make sure the doors and windows are closed; if a
heat source has been installed in the room that
raises the temperature excessively and for which
the air conditioner is unable to compensate, the only
solution is to install another air conditioner or replace
the existing one with a more powerful model.
The unit does not switch on
The unit does not cool/does not heat
sufficiently anymore
Electrical power is absent
The batteries of the remote control are
discharged
The temperature set on the remote control is too
high or too low (in the case the unit is with heat
pump);
The air filter is clogged before the relevant
cleaning warning light lights up
There are obstructions to the air flow inside or
outside
The thermorefrigerating load has increased (for
instance, a door or window have been left open,
or equipment has been installed in the room
which sinks a large quantity of heat);
ANOMALIES POSSIBLE CAUSES REMEDIES
- If any faults were to occur to the water condensation disposal system of the air conditioner it will come to a standstill and will signal
the malfunction using the OF alarm (see paragraph 2.5)
To enable the air conditioner to work temporarily until the service personnel arrives, you can drain the water out by following these
simple instructions:
- Disconnect the equipment from the mains
- Grasp the rubber cap on the bottom centre of the air conditioner behind the edge of the frame facing the wall between your thumb and
forefinger.
- Pull the rubber tube closed by the cap out by a few centimetres.
- Remove the cap after placing a bucket or other container underneath it (at least five litter capacity) to collect the water.
- After eliminating the malfunction the service personnel will take care of closing the evacuation tube.
- Connect the equipment to the mains
IMPORTANT: If you are unable to classify the problem as one of those described above, you should immediately get in
touch with our Service Department without attempting to make any repairs yourself.
4
321
LOW WALL VERSION
CEILING VERSION
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
123
Downloaded from AC-Manual.com Manuals
101


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Unico app at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Unico app in the language / languages: Dutch as an attachment in your email.

The manual is 9.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info