703047
16
Zoom out
Zoom in
Previous page
1/28
Next page
I GB
16
INSTALLAZIONE
1) Dopo aver tolto l’imballaggio, assicurarsi
dell’integrità dell’apparecchio; in caso di
dubbio non utilizzarlo e rivolgersi a personale
professionalmente qualicato.
2) Montare il corpo dell’apparecchio sulla
base eseguendo, nell’ordine specicato, le
seguenti operazioni:
- posizionare il corpo dell’apparecchio
sulla base stessa, assicurandosi che
l’interruttore anti-ribaltamento attraversi
il foro predisposto nella base per il suo
alloggiamento;
- ssare il corpo dell’apparecchio alla base
mediante i tre dadi ad alette forniti;
- inserire il cordone di alimentazione
nell’apposita scanalatura sul lato posteriore
della base.
3) Prima di collegare la stufa controllare che
i valori di tensione riportati sulla targa dati
corrispondano a quelli della rete elettrica, e
che la presa sia dotata di efcace messa a
terra. In caso di incompatibilità tra la presa
e la spina dell’apparecchio, far sostituire la
presa con altra di tipo adatto da personale
professionalmente qualicato, il quale accerti
che la sezione dei cavi della presa sia idonea
alla potenza assorbita dall’apparecchio. In
generale è sconsigliato l’uso di adattatori
e/o prolunghe; se il loro uso si rendesse
indispensabile, devono essere conformi alle
vigenti norme di sicurezza e la loro portata di
corrente (ampères) non deve essere inferiore
a quella massima dell’apparecchio.
4) L’apparecchio non deve essere posizionato
immediatamente al di sotto di una presa di
corrente.
5) La presa di corrente deve essere facilmente
accessibile in modo da poter disinserire con
facilità la spina in caso di emergenza.
6) Non utilizzare la stufa con un programmatore,
timer o qualsiasi altro dispositivo che
disconnetta automaticamente l’apparecchio
poiché esiste rischio di incendio nel
caso la stufa rimanga coperta o non sia
posizionata correttamente.
INSTALLATION
1) Afterremovingthepacking,makesurethat
theapplianceisintact;incaseofdoubt,donot
useitandcontactaprofessionallyqualied
person.
2) Assemblethebodyframeandthebaseplate
togetherasthefollowingsequences:
- positionthebodyoftheapplianceonthe
base,ensuringtheanti-toppleswitchgoes
throughtheappropriateholeonthebase;
 - fasten thebody of theapplianceto the
baseusingthethreewingnutsprovided;
 - routethepowercordintotheracewayon
therearofthebase.
3) Beforeconnectingtheheater,checkthatthe
voltageshownonthedataplatecorresponds
tothatofthemainssupply,andthatthesocket
isttedwithanefcientearthconnection.In
caseofincompatibility between thesocket
andtheplugontheappliance,theplugshould
bereplacedwithoneofasuitabletype,by
aprofessionallyqualiedperson,whoshall
ensurethatthe section ofthe plug cable
issuitablefor the powerabsorbedby the
appliance.Ingeneral,theuseofextension
cordsoradaptorsisnotrecommended;ifthey
areindispensible,theymustcomplywiththe
safetynormsinforceandtheircurrentow(in
amperes)mustnotbelessthanthemaximum
oftheappliance.
4) The appliance mustnotbe positioned
immediatelybelowasocket.
5) Themainssocketmustbeeasytoreach,so
that,incaseofemergency,theplugcanbe
removedwithease.
6) Donotusethisheaterwithaprogrammer,
timeroranyotherdevicethatswitchesthe
heatheronautomatically, since are risk
existsiftheheateriscoveredorpositioned
incorrectly.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Solaria Carbon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Solaria Carbon in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info