688885
126
Zoom out
Zoom in
Previous page
1/144
Next page
GB
F
D
126
I
RECOMMENDATIONS FOR
ENERGY SAVINGS
- Always keep the lters clean (see
chapter on maintenance and
cleaning).
- Keep the doors and windows
closed in the air-conditioned
rooms.
- Keep sunlight out of the room
by using curtains, lowering the
shades or closing the shutters.
- Do not obstruct the air flow
(intake and outlet) on the units;
this in addition to reducing the
performance of the system, will
jeopardize correct operation and
could cause irreparable damage.
FUNCTIONAL ASPECTS
NOT TO BE MISTAKEN FOR
ANOMALIES
The following events may occur
during normal operation:
1. PROTECTION OF THE AIR
CONDITIONER.
- The compressor can’t restart for
3 minutes after it stops.
- The unit is designed not to blow
cold air on HEAT mode, when the
indoor heat exchanger is in one of
the following three situations and
the set temperature has not been
reached.
A) When heating has just starting.
B) Defrosting.
C) Low temperature heating.
- The indoor or outdoor fan stop
running when defrosting
- Frost may be generated on the
outdoor unit during heat cycle
when outdoor temperature is low
and humidity is high resulting in
lower heating efciency of the air
conditioner.
- During this condition air
conditioner will stop heating
operation and start defrosting
automatically.
- The time to defrost may vary
from 4 to 10 minutes according
to the outdoor temperature and
the amount of frost buildup on the
outdoor unit.
3
CONSIGLI PER IL RISPARMIO
ENERGETICO
- Mantenere sempre e
costantemente puliti i ltri (vedi
capitolo manutenzione e pulizia).
- Mantenere chiuse le porte e le
nestre dei locali da climatizzare
- Evitare che i raggi solari penetrino
liberamente nell’ambiente (si
consiglia l’utilizzo di tende o
abbassare tapparelle o chiudere
le persiane)
- Non ostruire le via di usso dell’aria
(in entrata ed in uscita) delle
unità; ciò, oltre ad ottenere una
resa dell’impianto non ottimale,
pregiudica anche il suo corretto
funzionamento e la possibilità di
guasti irreparabili alle unità
ASPETTI FUNZIONALI DA
NON INTERPRETARE COME
INCONVENIENTI
Durante il normale funzionamento
è possibile che si verichi quanto
segue:
1. PROTEZIONE DEL
CONDIZIONATORE.
- Il compressore non si riavvia per
3 minuti dopo che è stato spento.
- L’apparecchiatura è concepita
in modo che non soffi
aria fredda nella modalità
RISCALDAMENTO, quando lo
scambiatore di calore interno
si trova in una delle seguenti
tre condizioni e la temperatura
impostata non è stata raggiunta.
A) Quando è appena stato
avviato il riscaldamento.
B) Sbrinamento.
C) Riscaldamento a bassa
temperatura.
- Il ventilatore interno o esterno
smettono di funzionare durante lo
sbrinamento
- La brina può prodursi sull’unità
esterna durante il ciclo di
riscaldamento, quando la
temperatura esterna è bassa e
l’umidità alta, cosa che provoca una
minore capacità di riscaldamento o
di condizionamento dell’aria.
- Se ciò si verica, il condizionatore
arresterà la modalità riscaldamento
ed attiverà automaticamente la
funzione di sbrinamento.
- Il tempo necessario per effettuare
lo sbrinamento può variare
dai 4 ai 10 minuti, a seconda
della temperatura esterna e del
quantitativo di brina che si è
formata sull’unità esterna.
CONSEILS POUR
L’ECONOMIE D’ENERGIE
- Maintenir toujours et constamment
les ltres propres (voir le chapitre
d’entretien et nettoyage).
- Maintenir fermées les portes et les
fenêtre des locaux à climatiser
- Eviter que les rayons de soleil
n’entrent librement dans la pièce
(on conseille l’utilisation de rideau
ou de baisser les stores ou de
fermer les persiennes)
- Ne pas obstruer les voies de
soufflage de l’air (en entrée
et en sortie) des unités; ceci,
outre à obtenir un rendement
de l’installation non optimal,
compromet aussi son correct
fonctionnement et la possibilité
de dommages irréparables aux
unités
ASPECTS FONCTIONNELS
A NE PAS INTERPRETER
COMME INCONVENIENTS
Pendant le fonctionnement normal,
les phénomènes suivants peuvent
se produire:
1. PROTECTION DU
CLIMATISEUR.
- Le compresseur ne redémarre
pas au bout de 3 minutes après
avoir été éteint.
- L’appareil est conçu de façon à
ne pas soufer l’air froid en mode
CHAUFFAGE, quand l’échangeur
de chaleur se trouve dans l’une
des trois conditions suivantes et
que la température programmée
n’a pas été atteinte.
A) Quand le chauffage vient juste
d’être activé.
B) Dégivrage.
C) Chauffage à basse
température.
- Le ventilateur interne ou externe
cesse de fonctionner pendant le
dégivrage
- Le givre peut s’accumuler
sur l’unité externe pendant le
cycle de chauffage, quand la
température externe est basse
et que l’humidité est élevée,
ce qui provoque une moindre
capacité de chauffage ou de
refroidissement de l’air.
- Si cela se produit, le climatiseur
arrête le mode chauffage et active
automatiquement la fonction de
dégivrage.
- Le temps nécessaire pour
effectuer le dégivrage peut varier
de 4 à 10 minutes, selon la
température extérieure et la
quantité de givre qui s’est formée
sur l’unité externe.
3.12
TIPPS ZUM ENERGIESPAREN
- Die Filter sind stets sauber zu
halten (siehe Kapitel „Wartung und
Reinigung des Klimagerätes”).
- Die Türen und Fenster der
klimatisierten Räume sind
geschlossen zu halten.
- Direkte Sonneneinstrahlung
in den Raum ist zu vermeiden
(Vorhänge zuziehen, Jalousien
herunterlassen oder Fensterläden
schließen).
- Die Öffnungen für den Luftein- und
austritt der Einheiten sind frei zu
halten, damit die Luft zirkulieren
kann. Ein nicht einwandfreier
Luftstrom beeinträchtigt nicht
nur die Leistungsfähigkeit der
Anlage, sondern auch die normale
Funktionsfähigkeit, wodurch
irreparable Schäden an der
Anlage entstehen können.
FUNKTIONALE ASPEKTE, DIE
NICHT ALS STÖRUNGEN ZU
VERSTEHEN SIND
Während des Normalbetriebs
können sich folgende Situationen
einstellen:
1. SCHUTZ DES KLIMAGERÄTES
- Der Kompressor schaltet sich 3
Minuten nach dem Ausschalten
nicht wieder ein.
- Das Klimagerät ist so konzipiert,
dass im Modus HEIZUNG keine
Kaltluft bläst, wenn sich der
Innenwärmeüberträger in einem
der folgenden drei Zustände
befindet und die eingestellte
Temperatur nicht erreicht wurde.
A) Wenn die Heizung gerade
gestartet wurde.
B) Abtauen.
C) Heizung bei niedriger
Temperatur.
- Die innere und äußere Ventilator
arbeiten nicht mehr während des
Abtauens
- Der Tau kann sich während
des Heizzyklus auf der
Außeneinheit bilden, wenn die
Außentemperatur niedrig und die
Feuchtigkeit hoch ist. Dies führt
zu einer geringeren Heiz- oder
Klimatisierungskapazität.
- Die Klimaanlage schaltet in
diesem Fall die Betriebsart
Heizung ab und startet
automatisch die Abtaufunktion
- Die notwendige Zeit zur
Durchführung des Abtauens
kann zwischen 4 und 10 Minuten
liegen, je nach Außentemperatur
und Taumenge, die sich auf der
Außeneinheit gebildet hat.
3.13
126


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid NEXYA S4 INVERTER 24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid NEXYA S4 INVERTER 24 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 7,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info