776121
24
Zoom out
Zoom in
Previous page
1/40
Next page
US-ENG- 12
US-ENGLISH
Atthispointthecurrentcongurationoftheunitwillbedisplayedforafewmomentsasshownbelow:
LED A(red)on:theunitisconguredasaheatpump;
LED B (green) on: the unit is setup for a low wall application(factory default);
LED C (yellow) on: the unit is setup for a low wall application;
LED D (green) on: reset settings function after an active black-out (factory setting).
AtthispointalloftheLEDsontheconsolewillstartashingsimultaneouslyfor10seconds.
Duringthistimethecongurationoftheunitcanbechangedbypressingtheresetkey(H)untilthesettings
matchyourspecicapplication.
Conguration of the control board for a high wall installation sets an automatic correction of the
detected room temperature by 5.5ºF (-14.7ºC).
At this point the troubleshooting function activates the unit in heating mode (if it is a heat pump) for approx. 2
minutes and then in cooling mode for another 2 minutes. It is possible to terminate the function prematurely,
by simply by switching the unit off using the remote control.
Shouldtheunitstopandsignalanerror,determinewhichLEDsareashingthenusethechartbelowto
determine the cause:
DESCRIPTION LED D
GREEN
LED C
YELLOW
LED B
GREEN
LED A
RED
Overtemperature of internal heat exchanger (HTI) OFF OFF ON OFF
Overtemperature of external heat exchanger (HTE) OFF OFF ON ON
External temperature sensor fault (short circuit) (TFS7) OFF ON OFF OFF
External temperature sensor fault (open circuit) (TFS8) OFF OFF OFF ON
Internal fan malfunction (SV) OFF ON OFF ON
Insufcientheatexchangertemperature(CF/RL) OFF ON ON OFF
Maximum level of condensate water (OF) OFF ON ON ON
Invalid EEprom parameters (CKS) ON OFF OFF OFF
Room temperature sensor fault (short circuit) (TFS1) ON ON OFF OFF
Room temperature sensor fault (open circuit) (TFS2) ON ON OFF ON
Internal heat exchanger temperature sensor fault (short
circuit) (TFS3) ON ON OFF OFF
Internal heat exchanger temperature sensor fault (open
circuit) (TFS4) ON ON OFF ON
External heat exchanger temperature sensor fault (short
circuit) (TFS5) ON ON ON OFF
External heat exchanger temperature sensor fault
(open circuit) (TFS6) ON ON ON ON
: ashing
WARNINGS DISPLAYED DURING NORMAL OPERATION SHOULD NOT BE INTERPRETED AS ERRORS.
LEDA:Indicatestheltermayneedcleaning.
AftercleaningorreplacingtheltertheLEDmustbeswitchedoffmanuallyasindicatedinsection2.6.1
LED B steady light: indicates high coil temperature signal.
LEDA+LEDCashing:Indicatescontinuouscondensatepumpoperation.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Maestro Smart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Maestro Smart in the language / languages: English as an attachment in your email.

The manual is 7.94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info