776121

Olimpia Splendid Maestro Smart Manual

21
Zoom out
Zoom in
Previous page
1/40
Next page
MAESTRO SMART
US-ENG- 9
US-ENGLISH
2.4.3 - ASSEMBLY OF THE AIR DUCTS AND EXTERNAL GRILLES (g.10-11-12)
• Afterhavingdrilledtheholes,inserttheplasticsleeves(suppliedwiththeunit)intothem.Sincethe
sleeves are made for 8” (200 mm) holes, the installer will have to trim 5.1” (129 mm) from the long side
of the sleeve, if using 6.4” (160 mm) holes.
The length of the sleeves must be 2.5” (63.5 mm) less than the thickness of the wall. Roll up the sleeves
and insert them into the hole. Pay attention to the splicing line (G) which must always face upwards.
To position the external grids, proceed as follows:
a. Applytheseal(D)tothewallange(F),ensuringitlinesupwiththeouteredgeoftheangeasindicated
inthegure13.
b. Fixthetwoangesusing2pegswithadiameterof1/4”(6mm)andcheckthatthetwoxingholesare
horizontal.
c. Fitthesmalleyeletofthespring,withthelongstem,onthecappin,onbothcomponents.(g.17)
d. Insert the two caps (with spring), on the front part of the external grille, on its two housings, pulling until
itclicks(g.18)thencouplethetwochainstothelargeeyeletofthespring.
e. Using one hand, grip the two chains connected to the grille.
f. Bendtheexternalgrilleback,grippingthemwithyourfreehandwheretheybendandinsertyourngers
insidethesinglelouvres(g.19).
g. Insert your arm into the sleeve until the grille protrudes completely outwards. reopen the grille, being
carefultokeepyourngersinsidethelouvres.
h. Turn the grille until the louvres are fully horizontal and tilted downwards.
i. Pullthechain,tensioningthespring,couplethechainringtothepinoftheinnerangethroughwhich
thesleevespass(g.20).
l. Use hand shears to cut off any excess chain links.
Olimpia Splendid recommends using the supplied grilles, or grilles with similar char-
acteristics that are factory approved to ensure proper unit performance.
2.4.4 - PREPARING THE HOLES ON THE UNIT
The unit is designed to operate with 6.4” (165 mm) sleeves, however to ensure the best performance and
lowest air noise level, the factory recommendation is to use the 8” (200 mm) holes. if using the 8” (200 mm)
sleevesuseacuttertoremovetheknockoutfromtherearoftheunit(g.21).
2.4.5 - FITTING THE UNIT ON THE BRACKET (g.22-23-24-25)
After ensuring the mounting bracket is properly anchored to the wall and that all required preparatory work
hasbeencarriedoutfortheelectricalconnectionsand/orthecondensatedrainagetheunitcanbexedto
the wall. Lift the unit by holding it from the sides of the lower base.
To facilitate the operation of fastening it to the bracket, tilt it slightly toward you. To make the electrical con-
nection and fasten the drain pipe, place a wedge between the unit and the wall.
Whenyouhavenished,inspectcarefullytomakesuretherearenoopenspacesattherearoftheunit.
Theinsulatinggasketmusttrmlyagainstthewall,particularlyintheareawhereairentersandleavesthe
unit.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Maestro Smart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Maestro Smart in the language / languages: English as an attachment in your email.

The manual is 7.94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info