703021
36
Zoom out
Zoom in
Previous page
1/124
Next page
EN - 10
6 - APPLIANCE INSTALLATION
6.1 - Wall installation
After removing the packaging, make sure of the appliance integrity; in case of doubts,
do not use it and please refer to professionally qualied personnel.
The appliance must be installed on a masonry or made of heat resistant material wall
(not wooden or made of easily overheatable synthetic material).
For the correct installation, work as follows:
The appliance must be installed:
in such a way as to prevent the ON/OFF switch and the buttons
from being touched by who is standing in the bathtub or in the
shower.
At a distance of at least 300 mm from walls
At a distance of at least 1000 mm from ammable materials (cur-
tains, textiles etc.)
DO NOT install the appliance beneath power outlets.
Prepare a power outlet in the vicinity of the appliance making sure
it’s not too far in relation to the power cord length (gure C).
a. Locate the area where the appliance is going to be installed.
b. Create two due 6mm holes with a centres distance of 494mm (gure D).
The holes must be at least 2000mm away from the oor 350mm
from the ceiling (gure D).
When piercing the wall, make sure that no electrical channels or
water hoses are present.
c. Insert the wall plugs in the holes and then fasten the supplied screws.
d. Do not fasten the screws entirely; leave them approximately 10 mm away from
the wall (gure E).
Make sure that the screws are well steady in the wall
.
e. Place the slots (X) on the rear part of the appliance on the screws pushing the
appliance itself against the wall (gure F - phase 1).
f. Push the appliance 10 mm towards the left (gure F - phase 2) then push it about
8÷10mm downwards (gure F - phase 3).
g. Lastly, check that the appliance is steady and well attached to the wall.
6.2 - Electrical connection
Before connecting the appliance plug to the power outlet, make
sure that the voltage values indicated on the data plate corre-
spond to the mains supply ones and that the outlet is equipped
with an ecient grounding.
In case of incompatibility between the outlet and the plug of the
appliance, let the outlet be replaced with another one of the suit-
able type by professionally qualied personnel, which verify that
the outlet cables section is suitable for the power absorbed by
the appliance. Generally, it’s not advised to use adapters and/
or extension cords; if their use should become essential, they
must comply with the current safety standards and their current
capacity (A) mustn’t be lower than the appliance maximum one.
The socket must be easily accessible so that the plug can be
removed easily in an emergency.
a. Insert the plug in the power outlet.
b. Press “I” (ON) on the switch (7); the appliance is ready for use.
This product has a ap that opens automatically when the product
is turned on and closes automatically when turned o.
- Do not move the ap with your hands. -
As this could damage or deform the unit. Open the ap with your
hands only if it accidentally closes in part or in whole.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olimpia Splendid Caldo Crystal at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olimpia Splendid Caldo Crystal in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 16,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info