563102
31
Zoom out
Zoom in
Previous page
1/81
Next page
Paper handling > 31
L
OADING
THE
OPTIONAL
CUT
-
SHEET
FEEDER
1. Ensure the Paper Type Lever is set to Cut Sheet.
2. Open the Top Cover and adjust the Paper Thickness Lever to suit the paper. See
“Setting the Paper Thickness lever” on page 33.
3. Remove the front sheet support (3).
4. Place the paper set lever in the RESET position (1).
5. Release the paper guides (2, 5) by pushing the locking levers (6) downward.
6. Move the left paper guide to the position where you wish to set the left-hand edge of
the sheet, making sure that this paper guide is not set to the right of the paper out
sensor (the grove in the platen).
7. “Flex a paper stack (not more than 170 sheets of 60 gsm paper). Square the stack,
turn over and repeat the bending. The stack of paper should not exceed 16mm
thickness.
8. Insert the paper stack into the hopper and push it against the left paper guide (5),
making sure that the paper fits under the corner separators.
9. Move the rear sheet support (4) to the center.
10. Adjust the right paper guide to the paper width (2).
NOTE
For installation instructions, see “Installing the Cut-sheet feeder” on page 73.
1. Paper Set Lever
2. Right Paper Guide
3. Front Sheet Support
4. Rear Sheet support
5. Left Paper Guide
6. Locking Lever
1
2
3
4
5
6
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oki ML5790 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oki ML5790 in the language / languages: English as an attachment in your email.

The manual is 5,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info