492971
625
Zoom out
Zoom in
Previous page
1/637
Next page
40055101TH Rev.4 625 /
5) When the setting is correct, enter [Y]. The system is now registered. If not correct, enter [N]. Then repeat
from step 1) again.
When registering the system, also register ANSI.SYS required for screen control and MOUSE.SYS for using
the mouse.
If RMCS is already set in the IBM PC/AT, RMCS SETTING MENU is displayed as below.
6) When updating, enter [Y]. Then updating status. When not updating, enter [N].
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
HARD DISK DRIVE = [C]
DIRECTORY = [C:\RMCS_ ]
PASSWORD = [ ]
DIPSW (ON:0 OFF:1) = [11000000]
Are you sure (Y or N)? Y
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
"RMCS" system already registered!
Over write OK ? Y
625


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oki Fax 5000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oki Fax 5000 in the language / languages: English as an attachment in your email.

The manual is 7,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info