492948
46
Zoom out
Zoom in
Previous page
1/62
Next page
Replacing consumable items > 46
F
USER
REPLACEMENT
The fuser is located inside the printer just behind the four image drum units.
Switch off the printer and allow the fuser to cool for about 10 minutes before opening the
cover.
1. Press the cover release and open the printer’s top cover fully.
2. Identify the fuser handle (1) on the top of the fuser unit.
Pull the two fuser retaining levers (2) towards the front of the printer so that they are
fully upright.
Holding the fuser by its handle (1), lift the fuser straight up and out of the printer. If
the fuser is still warm, place it on a flat surface which will not be damaged by heat.
3. Remove the new fuser from its packaging and remove the transit material.
4. Holding the new fuser by its handle, make sure that it is the correct way round. The
retaining levers (2) should be fully upright, and the two locating lugs (3) should be
towards you.
5. Lower the fuser into the printer, locating the two lugs (3) into their slots in the metal
partition which separates the fuser area from the image drums.
6. Push the two retaining levers (2) towards the rear of the printer to lock the fuser in
place.
7. Finally, close the top cover.
WARNING!
If the printer has recently been powered on, some fuser components
will be very hot. Handle the fuser with extreme care, holding it only by
its handle, which will only be mildly warm to the touch. A warning label
clearly indicates the area. If in doubt, switch the printer off and wait at
least 10 minutes for the fuser to cool before opening the printer cover.
1
2
2
2
3
2
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oki C3600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oki C3600 in the language / languages: English as an attachment in your email.

The manual is 4,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info