Chapter 7 Child’s bicycle seat OKBABY ORION Page 77
Instructions for use and assembly LIB003R03 Edition: 05-2005
Illustration 7:
If you want to replace the fastening
shackle, remove the closing caps (13)
and put the fastening shackle back into
place using the relative screw and nut,
tightening it with the wrench supplied
(14).
Illustration 8:
Fasten the child’s belt
Adjust the length of the belt according to
the child’s height.
Adjust the length of the belt:
move the length of the belts by sliding the
buckles of the belt. The belts must be
fastened firmly without the child being too
tight.
Fasten the belt system:
Close the belt. Check that the fastening of
the belt snaps correctly into position,
pulling the belt after the snap.
Undoing the belts:
Push the two buttons (front and rear) on
the closure at the same time.
The fastening is unblocked.
IMPORTANT/NOTE: To ensure maximum
safety, it has been made slightly difficult
to unblock the belt.
DANGER! The fastening of the belt
is an important element for safety and
must be inserted in all cases.
The correct fastening must be checking
before each ride!
The life of a child who is not secured is in
danger!
Instructions for use and assembly LIB003R03 Edition: 05-2005
Chapter 7 Child’s bicycle seat OKBABY ORION Page 76
WARNING! Always check that the
foot does not come out of its respective
footrest, pulling the child’s leg up.
Illustration 4:
The child’s fastening shackle, which is a
standard fitting on the seat you have
purchased, is very suitable for children
only a few months old (from 7 Kg to 10
Kg). When the child weighs more than 10
kg, the fastening shackle could be too
tight for the child and as a result it may be
necessary to remove it, thus being able to
use the seat for a child weighing up to a
maximum of 15 Kg.
To remove the fastening shackle, exercise
pressure with a normal screwdriver,
removing the cap blocking the pin.
Illustration 5:
At this point the pin can be extracted from
the housing, releasing the fastening
shackle.
DANGER ! The safety belts must
always be used even when the fastening
shackle is removed.
Illustration 6:
Snap into place the two caps (13) using
slight pressure, to close the openings that
have formed due to the absence of the
fastening shackle. 13
ENGLISH
ENGLISH