782971
18
Zoom out
Zoom in
Previous page
1/93
Next page
18
eN
24. Place the supply cord and, if necessary, an appropriate extension cable in such away that pulling or
tripping over it is impossible. Do not allow the supply cord to hang down within easy reach.
25. Do not jam, bend or pull the supply cord over sharp edges.
26. The power plug is used as the disconnect device; the disconnect device shall remain readily
operable. To completely disconnect the power input, disconnect the mains plug.
27. The product may not function properly or not react to the operation of any control due to
electrostatic discharge. Switch o and disconnect the product; reconnect after a few seconds.
28. Protect the supply cord from being walked on or pinched particularly at the plug, convenience
receptacles and the point where it exits from the product.
29. Never pull the plug by the supply cord or with wet hands.
30. Disconnect the power plug in case of faults during use, during lightening storms, before cleaning
and when not using the product for a longer period of time.
31. Danger! Before cleaning, switch the product o and disconnect the power plug from the socket.
32. When the product has reached the end of its service life, make it defective by disconnecting the
plug from the socket and cutting the cord in two.
33. Caution! There is danger of explosion from improper replacement of the batteries. Replace
batteries only with the same or equivalent type of battery.
34. Always change the entire battery pack. Do not mix old and new batteries, or batteries with dierent
charge state.
35. Make sure the batteries are correctly inserted. Observe the polarity (+) plus / (-) negative on the
battery and the housing. Improperly inserted batteries can lead to leakage or, in extreme cases, a
re or an explosion.
36. Remove used batteries. Remove the batteries if you know that the product will not be used for a
longer period of time. Otherwise, the batteries could leak and cause damage.
37. If the batteries leak, remove them with a cloth and dispose of them accordingly. Prevent battery
acid from coming into contact with skin and eyes. If you do get battery acid in your eyes, ush
them thoroughly with lots of water and consult a physician immediately. If battery acid comes into
contact with your skin, wash the aected area with lots of water and soap.
38. When installing the device, leave sucient space for ventilation. Do not install in bookcases, built-in
cabinets or the like.
39. Do not impede ventilation by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc. Do not insert any objects.
40. Non-rechargeable batteries must not be recharged.
41. The connections must not be short-circuited.
42. Remove the batteries from the product before disposal.
IM_OWR300-B_150129_V03_HR.indb 18 30/1/15 10:52 AM
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OWR 300-R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OWR 300-R in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 8.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info