783085

OK OPJ 4321 Manual

11
Zoom out
Zoom in
Previous page
1/74
Next page
11 EN
CONTROLS AND COMPONENTS
A. Pusher
B. Lid with feeding chute
C. Locking groove
D. Stainless steel sieve with blade
E. Sieve holder
F. Spout
G. Base with motor
H. Juice container
I. Locking bar
J. Power cord with power plug
K. Vacuum cup feet
L. On/o switch (O, 1, 2, P)
M. Pomace container
N. Container holder
DELIVERY CONTENT
1 x Juicer
1 x User manual
1 x Warranty card
BEFORE FIRST TIME USE
• Remove the product and accessories carefully from the original packaging. It is recommended to keep
the original packaging for storage. If you wish to dispose of the original packaging, please observe
applicable legal provisions. Should you have any questions regarding proper disposal, contact your
local waste management center.
• Check for completeness and transport damage. In case of damages or incompleteness please contact
your dealer.
• After unpacking, please refer to chapter Cleaning and care.
1 Before using the rst time, all removable parts should be cleaned.
Note: Wash all removable parts with water, mixed with a little detergent and then rinse and dry
thoroughly.
Alternative the parts A, B, D, E, H and M can also be cleaned in the dishwasher.
Disassemble the device as follows:
a) Put down the safety bar.
b) Remove the pomace container.
c) Remove the lid with the feeding chute.
d) Pull o the sieve holder upwards together with the sieve.
Note: The sieve holder is xed relatively tight. Pull from all sides, especially at the side of the
spout.
e) Remove the sieve from the sieve holder.
ASSEMBLY
WARNING! Never connect the power plug into an electrical outlet before the appliance is fully
assembled.
2 Place the base on a dry, at, and steady surface. Press the base rmly on the surface so that the
suction feet get a good grip.
3 Place the sieve holder on the base. Make sure sieve holder and spout t in place correctly.
4 Attaching the pulp container: Insert its upper part under the receptacle lip. Push the lower part
rmly into the pulp container holder.
5 Insert the stainless steel sieve inside the receptacle, matching its bottom with the base shaft.
6 Lock the sieve in place: Press the sieve edge downward until a click is heard.
7 Place the lid on the juicer.
8 Lock the bar: Lift up the locking bar until it ts the locking grooves on both sides of the lid.
IM_OPJ4321_181029_V07_HR.indb 11 29/10/18 10:43 am
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OPJ 4321 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OPJ 4321 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 8.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info