783040

OK OFK34411 A3 Manual

16
Zoom out
Zoom in
Previous page
1/99
Next page
16
Size = A5
EN
OPERATION
Fig. 4 Plug in the power plug into an appropriate mains socket outlet.
Note: Allow the product to precool for about 2-3 hours before storing food in it.
Setting the refrigerator temperature
Fig. 5 Set the temperature with the temperature control.
Levels 1-7 do not correspond to any particular temperature. In position 0 the appliance is
switched o. The lower the setting, the higher the inner temperature.
Note:
• To check the temperature, insert a commercially available thermometer into the device.
• The temperature in the unit depends on the ambient temperature and the setting of the
temperature controller.
• Make sure the door of the product is properly closed and not blocked by food.
Replace the light bulb
Warning! Disconnect the power plug before replacing the light bulb.
Fig. 6 To change the light bulb of the interior lighting, rst remove the screw and then the cover.
Unscrew the defective bulb and replace it with an equivalent model E14-5 (max. 10 W). Install
cover and screw again.
ADJUST THE SIDES OF THE DOORS
Note:
• If necessary, and if the premises require it, the mounting of the doors can be changed. To do this,
follow all the following instructions in the given order.
• The following tools are required:
10 mm wrench and Phillips screwdriver. Due to the uniqueness of the appropriate tools, those are not
mentioned separately in the following instructions.
• For this work a dierent cover is needed, which is provided with the unit.
• For safety, remove the door trays to prevent them from being damaged.
Top door
35. Remove the four caps in the upper plastic cover and unscrew all four screws. Remove the
plastic cover. Store all parts safely. Unscrew the upper hinge plate. When unscrewing, be sure to hold
the refrigerator door rmly, otherwise it will be damaged.
36. Pull out the door and place it on a soft and clean surface.
Bottom door
1. Hold the freezer door and remove the two screws on the middle hinge.
2. Pull the freezer door upwards and place it on a soft and clean surface.
3. Remove the two blind caps above the freezer compartment and the blind plug on the top of the
freezer door and insert them into the holes on the opposite sides.
Refrigerator bottom
Caution! Pull out the mains plug!
1. Tilt the refrigerator so you can work at the bottom or place the refrigerator fully on its back. Make sure
the back is placed on a soft and clean surface. Unscrew the feet on both sides using a hex-wrench.
Loosen the screws and remove lower hinge plate.
2. Remove the door hinge bolt, turn the hinge plate over and screw the door hinge pin in the same hole
from the other side.
3. Attach the turned hinge plate onto the left side by screws. Screw the feet into the plates on both sides.
Place the refrigerator back on its feet and adjust them if necessary.
IM_OFK34411-A3_190520_V06_HR.indb 16 20/5/2019 16:35
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OFK34411 A3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OFK34411 A3 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 8.15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info