783041

OK OFK 411 D Manual

21
Zoom out
Zoom in
Previous page
1/123
Next page
EN
21
Mounting the door
Caution!
After you have placed the refrigerator upright on its feet, wait for 2 hours
before you connect it to the mains to permit the cooling system to regain
full capacity.
1. Place the freezer door on the lower hinge. Flip the middle hinge over, insert the
bolt into the hole on the top of the freezer door, and screw the hinge in place.
Two plastic washers must sit on the bottom and one on top of the bolt. The pad
between the hinge plate and the refrigerator must also be attached. The freezer
door is now fixed. Check for correct function and fitting.
2. Remove the hinge pin counterpart with the door stop at the bottom of the
refrigerator door. Attach the supplied hinge pin counterpart with door stop to
the opposite side. Remove the blind cap on the top of the refrigerator door and
insert it into the hole on the opposite side.
3. Place the hole on the left side of the refrigerator door onto the middle hinge
pin and hold the door firmly. Insert the bolt of the upper hinge plate into the
designated left hole on the top of the refrigerator door. Screw the upper hinge
plate to the refrigerator. Check the correct function and the correct fit.
4. Clip the cover cap onto the upper hinge plate.
5. Attach the cap of the left side to the right side.
ENERGY SAVING TIPS
• Do not place the product in the vicinity of a heat source (radiator or kitchen
stove, etc.).
• Ensure unobstructed air flow around the refrigerator and freezer.
• If a layer of ice has built, defrost the unit. A thick layer of ice aects the
transmission of the cold, thus the energy consumption will be increased.
• When opening the door and taking out food, only open the door shortly. A
shorter door opening time causes less ice to deposit on the freezer walls.
• Select the temperature regulator setting according to the filling amount of the
product.
• Use drawers, baskets or shelves to store the food. If the energy of the product is
used eciently, the energy consumption can be minimized.
• It’s advised not to remove all accessories, such as drawers, shelves balconies, as
this might increase the energy consumption.
CLEANING AND CARE
Warning!
• Unplug the product before cleaning.
• When cleaning, never use solvents or abrasive materials, hard brushes, metallic or
sharp objects. Solvents are harmful to human health and can attack plastic parts,
while abrasive cleaning materials and tools may scratch the surface(s).
• Never use oil or grease on the door seal. This will make it porous over time.
• Do not use steam cleaning equipment. The steam may come in contact with
electrical parts of the product, causing a short circuit.
• Clean the product’s exterior surfaces with a slightly damp cloth and then dry
them thoroughly.
• Make sure that no water enters the product interior (for example, through the
switch).
IM_OFK411D_210126_V09_HR.indb 21IM_OFK411D_210126_V09_HR.indb 21 26/1/2021 09:4126/1/2021 09:41
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OFK 411 D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OFK 411 D in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 6.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info