554375
89
Zoom out
Zoom in
Previous page
1/102
Next page
89
b
c
da
Inspection (continued) -
• Closely examine the inside of the Battery Compartment(s) for any signs of corrosion
indicating entrance of moisture into the unit.
• If corrosion is found, return the VT Pro to an Authorized Oceanic Dealer, and DO NOT
attempt to use it until it has received factory service.
• If moisture is found, it is best to have the unit inspected and cleaned by an Authorized
Oceanic Dealer.
• If it is necessary to clean the Battery Compartment, flush it and all components with a
solution of 50% white vinegar and 50% fresh water. Rinse with fresh water, and allow
to dry overnight, or blow dry with a hair dryer (set at 'no heat').
Display Module Battery Installation
• Slide a new 3 volt type CR2450 Lithium Battery, negative (-) side down into the Battery
Cavity. Slide it in from the right side and ensure that it slides under the contact clip on
the left rim of the cavity.
• Orient the Retaining Bar across the lower portion of the Battery and carefully push it
down into position.
• Replace the Hatch O-ring with a new one. This O-ring must
be a genuine Oceanic part that can be purchased from an
Authorized Oceanic Dealer. Use of any other O-ring will
void the warranty.
• Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch. Ensure
that it is evenly seated.
• Slide the Hatch Ring, top portion first (small opening), onto
your thumb (Fig. 108).
Fig. 108 - Retaining Bar
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oceanic VT Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oceanic VT Pro in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oceanic VT Pro

Oceanic VT Pro User Manual - German - 102 pages

Oceanic VT Pro User Manual - French - 102 pages

Oceanic VT Pro User Manual - Italian - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info