554345
53
Zoom out
Zoom in
Previous page
1/60
Next page
53
VT 4.0 OPERATING MANUAL
© 2002 Design, 2011 Doc. No. 12-5213-r02 (9/6/11)
TRANSMITTER BATTERY REMOVAL
Locate the Battery Cover on the end of the housing:
Apply a coin to the recessed slot of the Cover and turn it counter clockwise out of the housing (Fig. 141).
Remove the Battery and discard it according to local regulations governing disposal of Lithium batteries.
TRANSMITTER BATTERY INSTALLATION
Lightly lubricate the new Battery Cover O-ring with silicone grease and install it onto the Battery Cover. DO NOT roll the
O-ring over the Threads, instead stretch it slightly to work it down over the slotted end of the Cover into the groove at the base
of the threads (Fig. 142).
The O-ring must be a genuine Oceanic part that can be purchased from an Authorized Oceanic Dealer.
Use of any other O-ring will void the warranty.
• Place a new 3 volt CR2 Lithium Battery (Duracell model DL-CR2 or equivalent) positive (+) side down into the Battery
compartment with the negative end facing up/out (Fig. 143).
• Ensure that the Battery is properly oriented and the Cover O-ring is evenly seated around the Cover.
• Carefully place the Cover (with Spring) into the housing and turn clockwise slowly by hand to ensure proper threading.
• Apply a coin and tighten until secure. The outer surface of the Battery Cover should be flush with the outer surface of the
housing (Fig. 144).
INSTALLING A TRANSMITTER ON A REGULATOR
• Remove the existing pressure gauge and high pressure hose, or the high pressure port plug from the port marked HP using
the proper size hex key.
• Lightly lubricate the o-ring and threads of the Transmitter fitting with a halocarbon based lubricant such as Christo-Lube
MCG111.
• Thread the Transmitter clockwise by hand into the regulator's HP port (Fig. 145) and tighten until secure with an appropriate
sized open end wrench.
• Attach the regulator First Stage to a full scuba tank and pressurize by slowly opening the tank valve, listening for any
indication of air leaking around the fitting.
• If air leakage is present, DO NOT use, take the complete regulator assembly to an Authorized Oceanic Dealer for inspection
and service.
TRANSMITTER COMPATIBILITY WITH NITROX
When packaged and shipped from the factory, Oceanic Transmitters are rated for use with compressed Air and/or nitrogen-
oxygen (Nitrox) breathing gas mixtures containing up to 99% O2 by volume and with 100% O2.
Fig. 143 - ORIENTATION
Battery
(+) ( - )
Fig. 141 - COVER
REMOVAL
Fig. 142 - INSTALLING
COVER O-RING
Fig. 144 - TRANSMITTER
COVER INSTALLED
Fig. 145 - TRANSMITTER ON
FIRST STAGE
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oceanic VT 4.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oceanic VT 4.0 in the language / languages: English as an attachment in your email.

The manual is 13,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oceanic VT 4.0

Oceanic VT 4.0 Quick start guide - English - 2 pages

Oceanic VT 4.0 Quick start guide - German - 2 pages

Oceanic VT 4.0 User Manual - German - 60 pages

Oceanic VT 4.0 User Manual - French - 2 pages

Oceanic VT 4.0 User Manual - French - 60 pages

Oceanic VT 4.0 Quick start guide - Italian - 2 pages

Oceanic VT 4.0 User Manual - Italian - 60 pages

Oceanic VT 4.0 Quick start guide - Spanish - 2 pages

Oceanic VT 4.0 User Manual - Spanish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info