551851

Oceanic OCS Manual

55
Zoom out
Zoom in
Previous page
1/62
Next page
55
OCS OPERATING MANUAL
© 2002 Design, 2011 Doc. No. 12-5272-r01 (9/28/11)
CARE AND CLEANING
Protect your OCS from shock, excessive temperatures, exposure to chemicals, and tampering. Protect the lens against scratches
with a Instrument Lens Protector. Small scratches will naturally disappear underwater.
• Soak and rinse the OCS in fresh water at the end of each day of diving, and check to ensure that the areas around the Low
Pressure (Depth) Sensor (Fig. 164a), PC Interface Data Port (Fig. 164b), and Buttons are free of debris or obstructions.
• To dissolve salt crystals, use lukewarm water or a slightly acidic bath (50% white vinegar/50% fresh water). After removal
from the bath, place the OCS under gently running fresh water and towel dry before storing.
• Transport your OCS cool, dry, and protected.
INSPECTIONS AND SERVICE
Your OCS should be inspected annually by an Authorized Oceanic Dealer who will perform a factory prescribed function check
and inspection for damage or wear. To keep the 2 year limited warranty in effect, this inspection must be completed one year
after purchase (+/- 30 days).
Oceanic recommends that you continue to have an inspection performed every year to ensure it is working properly. The costs of
annual inspections, or inspections relating to water tight integrity, are not covered under the terms of the 2 year limited warranty.
To Obtain Service:
Take your OCS to an Authorized Oceanic Dealer or send it to the nearest Oceanic Regional Facility.
To return your OCS to Oceanic:
• Record all dive data in the Log and/or download the data stored in memory. All data will be erased during factory service.
• Package it using a protective cushioning material.
• Include a legible note stating the specific reason for return, your name, address, daytime phone number, serial number(s),
and a copy of your original sales receipt and Warranty Registration Card.
• Send freight prepaid and insured using a traceable method to the nearest Oceanic Regional Facility, or to Oceanic USA.
• If shipping to Oceanic USA, obtain an RA (Return Authorization) number by contacting Oceanic at 510/562-0500 or send
an e-mail to service@oceanicusa.com.
• Non-warranty service must be prepaid. COD is not accepted.
• Additional information is available at the Oceanic web site OceanicWorldwide.com
BATTERY REPLACEMENT
CAUTION: The procedures that follow must be closely adhered to avoid entrance of water into the
unit. Damage due to improper Battery replacement (or subsequent leakage of moisture into the unit)
is not covered by the OCS's 2 year warranty.
NOTE: The OCS can be sent to Oceanic Worldwide, Regional Distributor, or Authorized Dealer Service
for proper battery change service which includes pressure (depth) and leak testing to the max operat-
ing depth. Standard charges for service will apply
The Battery Compartment should only be opened in a dry and clean environment with extreme care taken to prevent the entrance
of moisture or dust.
As an additional precautionary measure to prevent formation of moisture in the Battery Compartment, it is recommended that the
Battery be changed in an environment equivalent to the local outdoor temperature and humidity (e.g., do not change the Battery
in an air conditioned environment then take it outside during a hot sunny day).
Inspect the Buttons, Lens, and Housing to ensure they are not cracked or damaged. If there is any sign of moisture in the OCS,
DO NOT attempt to use it for diving (NORM, GAUG, or FREE) until it receives proper service by the Oceanic factory or an
Authorized Regional Distributor.
Data Retention
When the battery is removed, settings and nitrogen/oxygen calculations for repetitive dives will be retained in volatile memory
until a new battery is installed. You will have the choice of saving or deleting the data. The Compass will need to be calibrated
after the new battery is installed.
All parts needed for the battery change that follows are provided in the OCS Battery Kit available from your Oceanic Dealer.
Battery Removal
• There is no need to remove the straps.
• Remove the (4) retaining screws located on the back of the case (Fig. 165) by turning them counter clockwise with a small
flat tip 3mm screw driver.
• Carefully separate the front and back sections. If necessary, insert a small flat tip screw driver in the slot machined into the
Cover at the 11 o'clock position (Fig. 166A) and gently pry the Battery Cover loose, then lift it off the case (Fig. 166B).
• Turn the case to one side to drop the Battery into your hand. If necessary, gently loosen it with the tip of your finger (Fig.
167). DO NOT use tools to pry it out, or short the positive (+) top of the Battery to the negative ( - ) contact under it.
• Discard the Battery according to local regulations governing disposal of Lithium batteries.
Fig. 164 - FRONT
b
a
Fig. 165 - CASE BACK
Fig. 166B - LIFTING
BATTERY COVER OFF
Fig. 167 - BATTERY
REMOVAL
Fig. 166A - TO LOOSEN
BATTERY COVER
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oceanic OCS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oceanic OCS in the language / languages: English as an attachment in your email.

The manual is 9,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oceanic OCS

Oceanic OCS Quick start guide - English - 2 pages

Oceanic OCS Quick start guide - German - 2 pages

Oceanic OCS User Manual - German - 62 pages

Oceanic OCS Quick start guide - French - 2 pages

Oceanic OCS User Manual - French - 62 pages

Oceanic OCS Quick start guide - Italian - 2 pages

Oceanic OCS User Manual - Italian - 62 pages

Oceanic OCS Quick start guide - Spanish - 2 pages

Oceanic OCS User Manual - Spanish - 62 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info