554358
14
Zoom out
Zoom in
Previous page
1/92
Next page
4
G
LO
DATA
100
REGULATOR ATTACHMENT
If you have purchased the Data100 in a console version, you will need to have it
attached to your regulator first stage by an Authorized Oceanic Dealer.
ACTIVATING THE DISPLAY
You activate the Data100 by pressing and releasing the control button located
below the display (Fig. 1a). Depressing the button during the Dive Mode will
activate the display's Oceanglo™ backlight. After a diagnostic check that lasts
about 10 seconds, it enters the pre dive Surface Mode signified by the Surface
Mode icon (Fig. 1b). Also displayed will be the number "0" indicating that no
dive has been made since activation. The surface time display will start counting
up from 0:00. If no dive is made within 2 hours (2:00), the unit will automati-
cally shut off.
After displaying the Surface Mode for approximately 10 seconds, the Data100
automatically changes to a Plan Mode (Fig. 2) referred to as the Pre Dive Plan-
ning Sequence or PDPS signified by the PDPS icon (Fig. 2a). The PDPS
displays a sequence of depths from 30 to 160 feet (9 to 48 meters) in 10 foot (3
meter) increments. Each depth is displayed with its corresponding available
adjusted no decompression limit for 3 seconds. Upon completion of the Se-
quence, the Surface Mode is displayed, then the PDPS, etc.
Fig. 2 - Pre Dive
Planning Sequence
Fig. 1 - Surface Mode
FT
G
LO
DATA
100
b
a
a
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oceanic Data 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oceanic Data 100 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info