(1) Main Body
1 Sort tray (When sort copying or group copying, finished copies will
be ejected onto this tray. The Sort tray will automatically lower as
the number of copies increases and will be raised when the number
of copies is minimal.)
2 Non-sort tray (When copying in the Non-sort mode, copies will be
ejected onto the Non-sort tray. The maximum number of copies that
can be stored on the Non-sort tray will differ depending on the size
of copy paper that is being used. Refer to page 69.)
3 Finisher release button (Press this button to separate the Finisher
from the copier.)
4 Front cover (Open this cover if a paper jam occurs inside the
Finisher or when replenishing staples in the stapler holders.)
5 Front cover handle (Use this handle to open the front cover.)
6 Upper cover (Open this cover if a paper jam occurs during paper
ejection.)
7 Scrap hole-punch tank (The scraps left over from the hole puncher
are collected here.)
8 Scrap hole-punch tank knobs (Use these knobs to remove the
scrap hole-punch tank.)
9 Internal tray
0 Internal tray handle (Use this handle if a paper jam or other
problem occurs to pull out the internal tray.)
! Conveyor knob
AA
(Use this knob if a paper jam occurs between
the internal tray and the Sort tray.)
@ Conveyor guide handle
AA
(Use this handle if a paper jam occurs.)
# Conveyor guide handle
BB
(Use this handle if a paper jam occurs.)
$ Conveyor knob
BB
(Use this handle if a paper jam occurs.)
% Pressure adjustment lever
BB
(Adjust this lever when ejected
paper comes out curled.)
^ Stapling Unit handle (Use this handle when removing the staple
holder.)
& Staple holder release lever (Use this lever when removing the
staple cartridge.)
* Staple holder (Insert staples here.)
