679476
213
Zoom out
Zoom in
Previous page
1/218
Next page
213
16
Technical Specifications
Body-worn Operation
This device was tested for typical body-worn
operations. To comply with RF exposure
requirements, a minimum separation
distance of 1.5 cm must be maintained
between the user’s body and the handset,
including the antenna. Third-party belt-clips,
holsters, and similar accessories used by
this device should not contain any metallic
components. Body-worn accessories that
do not meet these requirements may not
comply with RF exposure requirements and
should be avoided.
FCC Part 15 Notice
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Warning: This device has been tested and
found to comply with the limits for a Class
B digital device pursuant to Part 15 of the
Federal Communications Commissions
Rules and Regulations. These limits are
designed to provide reasonable protection
against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instruction manual,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try and correct the
interference by one or more of the following
measures:
. Relocate this device
. Increase the separation between the device
and the receiver
. Connect the device into an outlet on
a circuit different from that of other
electronics. Consult the dealer or an
experienced radio technician for help.
FCC Radiation Exposure Statement
Important Note: To comply with FCC RF
exposure compliance requirement, the
antenna used for this transmitter must not be
co-located or operating in conjunction with
any other transmitter.
Caution:
Any changes or modications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate this equipment.
213


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for O2 Xda Flame at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of O2 Xda Flame in the language / languages: English as an attachment in your email.

The manual is 2,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info