663182
12
Zoom out
Zoom in
Previous page
1/120
Next page
12
EN
TECHNICAL OWNER MANUAL
3.4 Installing the Nfinity Hub Interface
1. Remove the anti-shift retainer, if installed
(reference section 3.2)
2. Ensure that markings between the splined
nut (A) and the shift driver (B) are aligned.
If not, refer to section 4.2
3. Prior to installation, set the Nfinity Hub
Interface to the full overdrive "H" position
(C).
N330 and N360/N380/ N380SE
series CVPs have different shift driver
configurations, and are compatible
only with the appropriate Nfinity Hub
Interface. Reference section 3.3
4. Suspend the Nfinity Hub Interface over the
right hand axle, and align the axle flats (D)
with the installation angle determined in
section 3.3
Alternatively, a no-turn washer (E) can be
installed over the Nfinity Hub Interface to
align the installation angle.
5. When the installation angle is aligned,
ensure the Nfinity Hub Interface is set to
full overdrive "H" and seat the Nfinity Hub
Interface fully onto the shift driver and the
spline nut until it is flush with the spline nut,
as shown.
NFINITY ASSEMBLY OF COMPONENTS
6. Thread the r.h. nut (F), serrations facing
outward, onto the axle and tighten to 10-
15 Nm (7-11 ft-lbs).
7. Install the rear wheel per section 2.5
C
D
E
BA
H
F
F
!
Image can differ from product based on product variant
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci Nfinity 330 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci Nfinity 330 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 11,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info