657528
12
Zoom out
Zoom in
Previous page
1/120
Next page
12
EN
TECHNICAL OWNER MANUAL
See section 8.1 (for chainline and beltline
specifications).
The NuVinci Optimized CVPs are
compatible with 16 to 28 tooth sprockets.
See section 8.1 for sprocket ratio
requirements and approved gearing.
3. If a Harmony Hub Interface is not installed
immediately following the sprocket, replace
the anti-shift retainer (A).
6.2 Installing the Sprocket
1. Remove the anti-shift retainer (A) by pulling
firmly away from the NuVinci CVP.
2. Install a standard 9-spline 3/32 inch
(2.3mm) sprocket (B) with the flat side
facing the CVP, followed by the supplied
sprocket spacer (C, if required), and secure
with the sprocket snap ring (D).
The sprocket spacer is intended for
sprockets that are 3/32 inch (2.3mm) thick
at the inner diameter. If the inner diameter
is 0.17-0.18 inch (4.3-4.5mm) thick, the
spacer should not be used.
A
B
C
D
Use of incompatible chains can result
in interference with the Harmony
Hub Interface and damage to CVP
components and may result in a dangerous
condition for the rider.
NuVinci Optimized CVPs are
incompatible with 1/8 inch (3.18mm)
single-speed chains and sprockets that
are flat on at least one side. Use 3/32 inch
(2.3mm) chains and sprockets only.
If the sprocket is asymmetric,
incorrect installation can result in
interference with the Harmony Hub
Interface and damage to CVP components
and may result in a dangerous condition for
the rider.
!
!
!
HARMONY ASSEMBLY OF COMPONENTS
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci Harmony 380SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci Harmony 380SE in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info