703082
6
Zoom out
Zoom in
Previous page
1/15
Next page
10
CLEANING SAFEGUARDS
AFTER MAKING A NUTRIBLAST OR SOUPERBLAST, THE BLADE MUST BE
CLEANED IMMEDIATELY.
ALWAYS UNPLUG POWER BASE AND DEPRESS THE POWER BUTTON PRIOR TO
CLEANING, ASSEMBLING OR DISASSBMBLING.
NEVER SUBMERGE THE POWER BASE IN WATER OR PLACE IT IN THE
DISHWASHER. WIPE OFF ANY DEBRIS INSIDE THE POWER BASE IMMEDIATELY
TO KEEP IT IN GOOD WORKING ORDER.
• DO NOT WASH THE BLADES IN THE DISHWASHER AS ELEVATED
TEMPERATURES CAN DAMAGE GASKET SEALS.
THE NUTRIBULLET Rx CUPS CAN BE WASHED IN THE DISHWASHER AND
SHOULD BE WASHED ON THE TOP RACK OF THE DISHWASHER USING THE
NORMAL (NOT SANITIZE) CYCLE.
THE NUTRIBULLET Rx CUPS AND BLADES SHOULD NOT BE EMMERSED IN
BOILING WATER FOR ANY REASON AS THIS WILL WARP PLASTIC AND
DAMAGE GASKETS.
BLADES ARE SHARP! USE CARE WHEN CLEANING BLADES TO AVOID INJURY!
RINSE BLADES IMMEDIATELY AFTER EACH USE TO PREVENT DEBRIS FROM
DRYING AND STICKING TO BLADE COMPONENTS. IF NECESSARY, USE
INCLUDED BRUSH TO LOOSEN AND DEBRIS AROUND BLADES, GASKETS AND
BLADE HOUSING THREADS WITH CARE.
HANDWASH ONLY WITH MILD DISH SOAP AND WARM WATER (NOT HOT).
• DRY IMMEDIATELY.
FOR TOUGH DEBRIS, FILL THE CUP ½ FULL WITH WARM (NOT HOT), MILD
SOAPY WATER. THEN, SIMPLY TWIST ON THE BLADE, POP IT ON THE BASE
AND GIVE IT A RUN FOR 30-45 SECONDS. FOLLOW UP WITH A QUICK BRUSH.
WHEN WASHING BLADES, DO NOT ATTEMPT TO REMOVE THE GASKET RING.
SIMPLY HAND WASH THE BLADES IN WARM, MILD SOAPY WATER. ATTEMPTED
REMOVAL OF THE GASKET MAY PERMANENTLY DAMAGE THE BLADE
CONFIGURATION AND CAUSE LEAKAGE.
STUBBORN CLEANUP
If ingredients dry inside the NutriBullet Rx Cups or SouperBlast Pitcher, make
your cleanup a snap by filling the cup about 2/3 full with warm soapy water and
screw on the Extractor Blade and if using the SouperBlast Pitcher, put on
lids. Place the cup assembly on the NutriBullet Rx Power Base for about 20-30
seconds. That will loosen the stuck ingredients, and with a light scrub and rinse,
you’ll be all done.
CLEANING THE NUTRIBULLET Rx
POWER BASE
For the most part the Power Base doesn’t really get dirty, but if you neglect to
twist the blade on to the cup tightly, liquids can leak out and get into the base and
activator buttons.
Here’s how to clean it up.
Step 1: The most important thing is to UNPLUG the Power Base before cleaning!
Step 2: Use a damp rag to wipe down the inside and outside of the Power Base.
NEVER SUBMERGE THE POWER BASE IN WATER OR PLACE IT IN THE
DISHWASHER.
Never put your hands or utensils near the moving blade and never use your hands
or utensils to press the activator buttons down while the Power Base is plugged in.
HEAVY CLEANING:
• Should the inside of the base become sticky due to spillage you may follow these
additional cleaning instructions:
UNPLUG the Power Base and depress the power button BEFORE cleaning.
• Place the Power Base on a dish towel to catch any liquid or debris.
• Pour a scant 1/8 cup of a dilute solution of distilled vinegar and warm (not hot)
water (1 part vinegar to 2 parts water) in to the Power Base where the blade
assembly would sit during normal use.
• Immediately use a dish brush to dislodge any debris and wipe it out with a damp cloth.
• The Power Base is constructed with a drain tube to drain any liquid debris safely
through to the dish towel without damaging the inside components.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
11
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NutriBullet RX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NutriBullet RX in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NutriBullet RX

NutriBullet RX Manual - English - 85 pages

NutriBullet RX User Manual - German - 72 pages

NutriBullet RX User Manual - Dutch - 28 pages

NutriBullet RX User Manual - French, Italian - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info