564480
24
Zoom out
Zoom in
Previous page
1/32
Next page
24
Diagnostic software is available via your service engineer.
Nacecare dealer or the Nacecare Technical help line
+44 (0) 900 1 905 785 0038
PROBLEM CAUSE SOLUTION
Machine will not operate Missing or blown fuses
Key in the ‘OFF’ position
Low battery charge
Machine isolator button in ‘OFF’ mode
Machine is connected and charging
Waste tank full switch stuck or clogged
Fit or replace fuse (page 7)
Turn key to ‘ON’ position (page 7)
Charge batteries (page 19)
Reset isolator (page 15)
Take off charge (page 19)
Inspect and clean switch (page 14/17)
Vacuum will not operate Floor tool in raised position
Waste water tank full
Lower oor-tool (page 12)
Empty waste water tank (page 17)
Poor water pick-up Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket lter clogged / blocked
Separator lter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged oor-tool blades
Low battery charge
Empty waste-water tank (page 17)
Remove and clean (page 17)
Push tight connections (page 16)
Remove and clean (page 17)
Remove and clean (Page 17)
Clean and ret (page 17)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries (page 19)
No brush / scrub function No brushes tted
Brush deck raised
Check and t (page 9)
Lower brush deck (page 12)
Little or no water ow Clean-water tank empty
Clean-water tank lter blocked/ clogged
Incorrect water ow setting
Brush deck raised
Fill clean-water tank (page 10)
Remove and clean (17)
Adjust as desired (Page 13)
Lower brush deck (page 12)
Little or no dosing solution ow Chemical dosing tank empty
incorrect dosing ow setting
Fill dosing-tank (page 11)
Adjust as desired (page 13)
Machine just ‘stops’ while
operating
Too much load on the brush system Reset the machine using the key and
decrease the brush load to best suit
the oor type (page 14)
Machine will not operate in reverse
Floor-tool in lowered position
‘Causes Battery Indicator to Flash’
Raise oor-tool (page 12)
Trouble-Shooting
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Numatic TTV 678-300T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Numatic TTV 678-300T in the language / languages: English as an attachment in your email.

The manual is 4,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info