Manual Numatic TTB-1840 (page 32 of 52) (English, German, Dutch, French)

473152

Zoom out

Zoom in

1/52

233970 (Page 32) 10/11 (A13)

Setting the cleaning controls

To start: hold down either trigger and press the yellow start

button once (Fig 26).

Whilst the brush motor is running press the tap On / OFF

button for uid control (Fig 27a), the clean tank tap must be

open.

Ideally set the tap to 45

(Fig 27) this enables the cleaning

solution to last the same time as a fully-charged battery .

When the triggers are released the brush motor and the

cleaning solution pump will switch off, the vacuum motor will

continue for 10 seconds.

Press the cycle button to operate the brush only

(Fig 27b).

The start sequence is required in this mode.

The tap button will operate in this mode.

Press the cycle button again to get vacuum only.

The start button and triggers are not required in this mode.

(Fig 27c).

Press the cycle button to switch this mode off and return to

default mode.

The panel if unused will automatically turn off after 60

seconds.

To activate the control panel: press the cycle button or press a trigger (Fig 26).

Brush overload.

The brush LED light will ash if the brush motor has been

overloaded (Fig 27d).

Releasing the handle triggers will allow the machine to stop

and reset.

If the brush motor keeps overloading

consider using a different type of brush.

Heavy brush load decreases the available battery run

time.

Fig 26

Fig 27

1 1

(Fig 27a)

(Fig 27b)

(Fig 27c)

(Fig 27d)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Numatic TTB-1840 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 19,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Numatic TTB-1840 Manual

Product: