473156

Numatic TT 4550S Manual

13
Zoom out
Zoom in
Previous page
1/28
Next page
233752 05/11 (A06)
13
CAUTION:
Read the instruction manual before using the appliance
NOTE:
This Product meets the requirements of BS EN 60335 - 2.72
This Machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and
ofces for other than normal housekeeping purposes.
Care should be taken in the choice of chemicals, detergents and other liquids. Consult your supplier.
Do’s and Don’ts:
DO Ensure only competent persons unpack/ assemble the machine.
DO Keep your machine clean.
DO Keep your brushes in good condition.
DO Replace any worn or damaged parts immediately.
DO Daily examine the mains lead for damage, such as cracking or aging. If damaged is found, replace the lead
before further use.
DO Only replace the mains lead with the correct Numatic approved replacement part.
DO Ensure that the work area is clear of obstructions and/ or people.
DO Ensure that the working area is well illuminated.
DO Pre - sweep the area to be cleaned.
DON’T Use steam cleaners or pressure washers to clean the machine or use in the rain.
DON’T Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
DON’T Allow any inexperienced repairs. Contact your nearest service centre.
DON’T Strain the mains lead or try to unplug by pulling on the mains lead.
DON’T Leave the brush deck in the lowered position when not in use.
DON’T Expect the machine to provide trouble free, reliable operation unless maintained correctly.
DON’T Run the machine over any power cables during operation.
WARNING:
Operators shall be adequately instructed on the use of this machine.
This machine shall be disconnected from its power source (Remove plug from socket outlet.) During cleaning or
maintenance or in the event of an accident and when replacing parts or converting the machine to another function.
This machine is not suitable for picking up hazardous dust.
Ensure machine is switched OFF when not in use.
Do not use on slopes - Refer to maximum gradient quoted on the rating label.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
As with all electrical equipment care and attention must be exercised at all times during its use, in addition to ensuring
that routine and preventive maintenance is carried out periodically in order to ensure its safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render
the equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the model number / serial number specied on the rating plate.
This machine is for indoor use only.
The machine is not to be used or stored outdoors or in wet conditions.
Don’t allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
Only use brushes provided with the appliance or those specied in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specic task being
performed.
It is essential that this equipment is correct assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
The 110V / 120V machines have been tted with a motor overload trip.
If the trip is activated wait 15- to 30 seconds before resetting.
The reset button can be found on the machine handle.
Note:
This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capa-
bilities, or lack of experience and knowledge.
Unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
for their safety.
ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
Information for Scrubber Dryer
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Numatic TT 4550S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Numatic TT 4550S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 24,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info