564495
17
Zoom out
Zoom in
Previous page
1/32
Next page
17
577877 Top Tank - Red 208638 Wheel
577878 Bottom Tank - Red 577812 Deck
577839 Separator 577892 Handle
206265 Barrel Filter 321686 Vac Motor
207000 Basket Filter 208588 Vac Hose
206698 Floor Tool Hose 221107 50 Amp Fuse (Batteries)
213047 Dump Hose Top 206813 Isolator Pin \ Key
303641 Dump Hose Bottom 229295 Floor Tool Retaining Pin
606309 Floor Tool 206953 Detent Pin
606028 Polyscrub Brush 20” 606551 Long Life Brush 20”
606550 Nyloscrub Brush 20” 606403 Padloc Drive Board 20”
606037 Recommended oor tool Blade Set 606071 Replacment Polyurethane Blade Set (optional)
ETB 1120
Brush Motor Vac Motor Brush Sizes
Pad
sizes
Weight
Protection
Class
Power
400W 400W 20’ 20’ 335 lbs IPX4 2 x 12V (24V) 100Ah
Fluid Flow Speed Cleaning Speed Hand Arm Vibration Noise Size
0.53 gpm
100 rpm
0 - 0.31mph 0.57 m/s
2
Hi-69 dB(A)
Lo-67 dB(A)
Width - 22’
Length - 40.5’
Height - 45.6’
PROBLEM CAUSE SOLUTION
Machine will not operate Missing or blown fuses
Battery not connected
Low battery charge
Fit or replace fuse
Connect battery
Charge batteries (page 16)
Vacuum will not operate Vacuum not turned on Turn on vacuum (page 13)
Poor water pick-up Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket lter clogged/blocked
Separator lter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged oor-tool blades
Low battery charge
Empty waste-water tank (page 14)
Remove and clean (page 14)
Push tight connections (page 14)
Remove and clean (page 14)
Remove and clean (page 14)
Clean and ret (page 14)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries
No brush / scrub function No brushes tted
Brush overloaded
Check and t (page 10)
Reset machine (page 13)
Little or no water ow Clean-water tank empty
Clean-water tank lter blocked/ clogged
Clean water tap not turned on
Fill clean-water tank (page 11)
Remove and clean (page 14)
Turn on clean water tap (page 9)
Machine just ‘stops’ while
operating
Too much load on the brush system
Blown fuse
Reset the machine and decrease the
brush load to best suit the oor type
(page 13)
Replace fuse
Trouble Shooting
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Numatic ETB 1120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Numatic ETB 1120 in the language / languages: English, French as an attachment in your email.

The manual is 4,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info