161822
15
Zoom out
Zoom in
Previous page
1/16
Next page
TROUBLE SHOOTING PAGE 14
Turntable does not turn on. Disconnected Power Cord? Connect Power Cord.
The sound level is very low. The Turntable is not connected to a
device with a PHONO preamp.
Connect the device to a preamp DJ
mixer or an AV receiver that has an
input labeled PHONO, not AUX or
LINE.
Problem Cause? Solution
The sound is on one side only. The Cartridge is not properly wired. Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
Reconnect the wires from the
headshell to the cartridge. See the
"Cartridge Setup" section for more
detail.
The Stylus is worn out. Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
The Stylus is worn out. Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
The RCA audio cord is
disconnected.
The RCA audio cord is damaged.
Properly secure the RCA cable to
the preamp device and the bottom
of the turntable. See the "Cable
Connections" section for more
detail.
If the RCA cord is frequently
connected and disconnected, it
may have become damaged and
needs to be replaced.
The output sound is very distorted. The Cartridge is not properly wired.
NOTE:
Static electricity and/or other external interference may cause this unit to malfunction. To reset the unit to its normal
condition, turn the power off and then on again. If the problem continues to persist, refer to the connected component's
troubleshooting guides. If the problem is not resolved after checking these items, contact the nearest authorized Numark
dealer.
The Output sound exhibits
excessive hum or buzzing.
The Turntable Grounding wires are
not connected.
Connect the Turntable Ground
wires to their respective Grounding
Lug on all equipment (mixer, etc.)
The turntable skips like crazy. The Turntable is on an unstable
surface.
Follow the guidelines for installation
in the "Setup & Installation"
Section.
The Tone Arm is not balanced
properly.
Follow the guidelines for optimum
setup in the "Tone Arm Setup"
Section.
The Stylus is worn out. Replace the stylus on the cartridge.
Replacement styli are available
from most Numark Retailers.
The record is warped. Buy new records.
Excessive force is being applied
directly down on the platter.
Reread the "Operation" section of
this manual.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Numark tt 1650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Numark tt 1650 in the language / languages: English as an attachment in your email.

The manual is 1,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info