Manual Numark DM1125 (page 11 of 16) (English)

23488

Zoom out

Zoom in

1/16

DM1125

DIGITAL SAMPLER SECTION

The Sampler uses dynamic RAM with a 12-bit

microprocessor controller. The same digital signal

processing components used in professional audio

equipment deliver high-quality samples.

25. The Mode Knob switches from effect to effect.

Modes are:

• Loop sets the unit to play back a sample and automatically

repeat when it gets to the end of the sample.

• Single sets the unit to play back a sample once.

• Write sets the unit to sampler record ready. Depress the

appropriate assign button to select the source you wish to

record. Selecting a bank you wish to record to and hit the

Start/Stop button (#30) to begin recording (it is safer to

actually choose your bank before going to write mode so

that you don't accidentally wipe out an existing sample). The

LED will stay lit while you are in Write mode. After you are

done writing your sample you should select a play mode

(either Single or Loop) and listen to your sample.

TO RECORD A SAMPLE

a - Select the Write mode to go into stand by mode.

b - Select the bank (or multiple banks) into which you want

to record. Any bank can be selected. Each bank contains 6

seconds of recording time. If you want to record a longer

sample select multiple banks (they must be adjoining). To

playback a multi-bank sample you must reselect the same

banks later. Note: To overwrite an existing sample, select

that bank instead of an empty bank. Changing bank

selection at this point in time is possible and will not destroy

any previously recorded samples.

c - Hit the Start-Stop button to begin recording. The red

LED will light.

d- Hit Start-Stop a second time to stop the sampling, or

allow the memory banks to fill up, at which time sampling will

stop automatically. Once your writing is complete, switch to a

playback mode. The sampler is now ready for playback.

27. The Speed Control plays samples faster or slower

resulting in a pitch shift of the sample. In the center position,

the sample is played at recorded speed. Moving the knob to

the left will slow down playback by up to 50%; moving the

knob to the right will speed up the playback by up to 200%.

Positions near the center provide fine changes in playback

speed. Positions further from the center detent provide

more drastic changes in playback speed.

28. Effect Level Mix fader. This precisely sets the

audible level of the sample in the mix.

29. Memory Bank Select Pushbuttons A-D.

Four banks are available for storing samples. To

record a bank go to Write and then hit the bank

button. You can record into any combination of banks

by pressing multiple bank buttons. After sampling,

you can either select the next bank and record it

(remember Write is still on, just select the bank and

hit Start/Stop) or you can manually select a playback

mode.

• You can play any combination of the Memory Banks

from left to right (that is, Memory Bank B will always

play before Memory Bank D - but you can play ABCD;

BC; BD: ACD; only C; only D; etc.).

30. The large Start-Stop button controls sample

recording and sample playback. The small red Effects

Indicator LED glows when the sampler is "on". Here

are the functions:

• Tap the button when in sampler Write mode to

begin sampling (the LED will light). Tapping it again

ends the sample and the LED goes out. (unless the

sampler has run out of memory and shuts off

automatically.

• In single or loop play without Trigger, tap the

button to play the sample and tap it again to stop the

playback. Every time you play the sample, the music

starts from the beginning of the sample.

• In Single or Loop play with Trigger you are

ready to "stab" samples. With the Trigger Out, the

sample plays all the way through before you can play it

again. With it In, you can stab or stutter a sample.

When you shout "Rock it - rock the house!" and

sample it, it can be played back as -

R-R-R-R-R-R-R-Rock --

Rock-Rock-Rock it - Rock it Rock it -

Rock - - Rock it - rock the house!

by simply "drumming" with your fingers.

31. Monitor Pushbutton. To hear the sample or

effect in the headphones, press this button.

Program Mix still works and you will be able to hear

any other input channels with the Cue buttons

activated.

Numark - The Proven Leader in DJ Technology

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Numark DM1125 in the language / languages: English as an attachment in your email.

The manual is 0,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Numark DM1125 Manual

Product: