803241

Nuk Eco Control Audio 500 - 10256438 Manual

8
Zoom out
Zoom in
Previous page
1/15
Next page
26
As soon as the connection has been set
up the connection indicator 13 will again
light up green.
4.4 Power supply
• The power supply for the baby unit 1
works only via the mains adapter.
• The parent unit 8 can be operated with
no mains connection using the battery.
The state of the battery is indicated by the
POWER 15 LED. If it:
– lights up green: the device is switched
on and the battery is fully charged;
– flashes green: the battery is currently
being charged;
– lights up red and beeps at one minute
intervals: low battery warning. Within
about 15 – 20 minutes the parent unit
will switch off automatically.
During these 15 minutes you can still
activate and deactivate any functions
you wish. Please be aware that using
e.g. the Talk-Back function and/or
maximising the volume control will
increase the unit’s power consumption
and therefore reduce the remaining
time you have available. You should
connect the mains adapter to your
mains supply as soon as the
POWER 15 LED begins to flash red.
• The parent unit can be connected to the
mains via the mains adapter and receive
power from there, while at the same time
recharging the battery. If the parent unit is
switched on, recharging the battery will
take somewhat longer. While the battery
is charging, the LED 15 flashes green.
Notes:
– With a fully charged battery you can
operate the parent unit for up to
18 hours. The exact time will depend
on how the unit is used (whether the
parent unit frequently switches on,
whether the two-way speaking function
is much used, how high the volume is
set, etc.).
– Charging an empty battery takes about
5 hours.
4.5 Eco-Mode
Description of function
This babyphone has an Eco-Mode setting,
which not only saves electric power but also
minimises the high-frequency radiation in
the nursery.
At VOX levels 1, 2, 3 and 4, (see "6.3 Using
the VOX function to adjust the transmission
sensitivity" on page 28) Eco-Mode is
activated automatically about 10 seconds
after your baby goes to sleep and no longer
makes any noise.
You can see when this happens because the
connection indicator 13 will begin to flash
green. In Eco-Mode, not only the baby unit
is automatically set to standby, but also the
parent unit.
While Eco-Mode is activated, any functions
that might wake the baby are automatically
deactivated. For example, you cannot use
the Talk-Back function, but even in Eco-
Mode you are always connected to your
baby and always know if you are still within
range.
This babyphone has a range checker that
also works in Eco-Mode. If you are out of
range, you will automatically receive a
warning even if Eco-Mode is activated,
because even in standby mode, the baby
unit sends a signal to the parent unit every
30 seconds to check the connection.
If the connection indicator 13 lights up
green, there is a functioning connection
between the baby unit and the parent unit. If
the connection indicator 13 flashes green,
Eco-Mode has been activated. If the
connection indicator 13 changes to red, this
means that you are out of range and/or the
two units are no longer communicating.
Note: Check the range of your baby monitor
before using Eco-Mode. Make sure that the
two units are always within range, so that
you can hear your baby.
The device automatically switches to
transmission mode as soon as your baby
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nuk Eco Control Audio 500 - 10256438 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nuk Eco Control Audio 500 - 10256438 in the language / languages: English as an attachment in your email.

The manual is 0.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nuk Eco Control Audio 500 - 10256438

Nuk Eco Control Audio 500 - 10256438 User Manual - English - 15 pages

Nuk Eco Control Audio 500 - 10256438 User Manual - German - 20 pages

Nuk Eco Control Audio 500 - 10256438 User Manual - Dutch - 16 pages

Nuk Eco Control Audio 500 - 10256438 User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info