534374
13
Zoom out
Zoom in
Previous page
1/17
Next page
EN 13
GENERAL INFORMATION
General
These are the mounting instructions for the Novy hood shown on the cover. The manual is a separate booklet that
has been supplied with this hood. Read these instructions carefully before installing and commissioning the hood. It is
recommended to have one or more qualified persons carry out the installation.
Carefully take the hood from the packaging. Check if all mounting materials have been supplied using the drawings on
page 2.
The hood is to be used above a cooking plate and/or domino and it is intended for household use only. The built-in unit
is to be placed in a self-constructed recessed housing.
The recommended minimum overall height is: 60 cm over an electrical/ceramic cooking plate, 65 cm over a gas or an
induction cooking plate. The recessed housing must at least fully bridge the cooking plate. The built-in unit is preferably
mounted centralised over the cooking zones.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
For easier mounting of the ceiling unit, it is recommended to do this with at least 2 persons.
Position the wall socket in such a way that it is behind the ceiling unit.
Make sure that the ceiling has sufficient load bearing capacity.
Remove the protective film from the stainless steel parts of the ceiling unit before mounting. Avoid damaging the
stainless steel.
Exhaust or recirculation
Before starting any mounting activities, you must have made the choice if you are going to make an exhaust duct to the
outside or if you are going to use the hood as a recirculation hood. In case of an exhaust duct to the outside, carefully
read the section in these mounting instructions for installing the exhaust duct. If you choose for recirculation, Novy offers
the exhaust box (see accessories).
InTouch
InTouch offers the option to control the Novy cooker hood from the Novy InTouch induction hotplate. The ceiling unit
may, as a default, be combined with InTouch induction hotplates. Visit the website for the different models of induction
hotplates with InTouch
INSTALLATION
Proceed following the mounting drawings on page 2 and 3.
1
Make a build-in opening:
Type 6830 / 6831 – Cut-away 845mm x 485mm.
Type 6840 / 6841 – Cut-away 1145mm x 485mm.
The ceiling unit can be built into plates with a thickness of 18-35mm. Do not mount directly into gypsum board; al-
ways make sure there is reinforcement for the tightening of the mounting clamps. Make sure there is a socket near
the ceiling unit, so that the power may, at all times, be removed from the ceiling unit.
2
Changing the exhaust direction of the motor (if desired).
Sideways:
- Open the bottom plate and remove the filters from the ceiling unit.
- Disconnect the cord that connects the motor to the ceiling unit.
- Loosen the 8 screws located next to the protective grid.
- Turn the motor with the exhaust into the desired position and screw the motor back on using the 8 screws.
3
Changing the exhaust direction of the motor (if desired).
Top:
A Loosen the 6 screws on the motor cover.
B Turn the motor cover a quarter turn and place the motor cover back into the motor housing. Screw it back on again
using the 6 screws.
4
Connect the exhaust duct to the connection nozzle by means of a hose clamp (keep in mind the length of the exhaust
duct in case of removal, if necessary).
Put the plug into the wall socket.
Push the ceiling unit up into the build-in opening by pushing on the edges (not on the bottom plate) until you hear a
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novy D6831 Pureline at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novy D6831 Pureline in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Novy D6831 Pureline

Novy D6831 Pureline User Manual - English, German, Dutch, French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info