534373
16
Zoom out
Zoom in
Previous page
1/24
Next page
EN 16
Programming the remote control
The remote control for hood and hob are
preinstalled and ready for use. Only when te
remote control needs to be reprogrammed
(interaction with other controls)act as in the
following.
Determine the code used:
Simultaneously press on/off + the key with the
sun. The lamp flashes as well as the selected
code (there are 10 code options in total).
Change the code:
a. Simultaneously press on/off + the key with
the sun for 3 seconds until the lamp is flash-
ing. After this the lamp as well as the selected
code will flash. Repeat this step until you have
reached the required code (there are 10 code
options in total).
b. Simultaneously press + lamp of the roof cover
control until the second green LED is blinking.
c. Press the key with the sun on the remote con-
trol within 10 seconds to confirm the settings.
The cooker hood and the remote control are
now in line with each other.
Change the batteries:
For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the
new ones. Pay attention to the polarity marking
given in the battery compartment (figure 4).
Empty batteries are not to be disposed of in
the household refuse, but they are to be hand-
ed in as chemical waste.
NOVY key:
You can switch on the ambient lighting using the
NOVY key (figure 5).
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
Maintenance
Maintenance of the grease filter
The hood contains two metal filters which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don’t reset, the LED lights will continu blinking.
We advise you to clean your filter twice a month
for an optimal operation.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook
and pulling down.
Cleaning the filter:
in the dishwasher
manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
The red LED will light up after 200 working hours
(time to regenerate the used carbon filter).
Follow the instructions below:
Open the bottom plate.
Take the filter from the hood.
Take the Monoblock recirculation filter from
the hood.
ATTENTION: Do not pull the fabric of the
Monoblock filter!
Regenerate the Monoblock recirculation filter:
The Monoblock can be regenerated up to 12
times. This is done in the oven.
Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novy D6830 Pureline at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novy D6830 Pureline in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Novy D6830 Pureline

Novy D6830 Pureline Installation Guide - English, German, Dutch, French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info