571908
16
Zoom out
Zoom in
Previous page
1/24
Next page
EN 16
Illumination
To activate the lights press button . The lights
will switch on at full power.
Lighting can be activated independently from the
motor.
OPTION: kit for remote control (InTouch)
Optionally, there is a kit for a remote control
available which must also be installed if you se-
lect InTouch. If you have a Novy induction hob
with the InTouch function, you can operate all
of the functions of the extraction hood via the in-
duction hob with the optional kit. This kit must be
mounted during the installation and exclusively by
an authorized installer.
MAINTENANCE
Maintenance of the grease filter
The hood contains two metal filters which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don’t reset, the LED lights will continu blinking.
We advise you to clean your filter twice a month
for an optimal operation.
Access to the filter
Take hold of the right and left side of the plate (A)
and pull towards you simultaneously.
Remove the filter (B) by taking hold of its hook
and pulling down.
Cleaning the filter:
in the dishwasher
manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
The red LED will light up after 200 working hours
(time to regenerate the used carbon filter).
Follow the instructions below:
Open the bottom plate.
Take the filter from the hood.
Take the Monoblock recirculation filter from
the hood.
ATTENTION: Do not pull the fabric of the
Monoblock filter!
Regenerate the Monoblock recirculation filter:
The Monoblock can be regenerated up to 12
times. This is done in the oven.
Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released.
Smells can be released when baking certain
kinds of fish. The best solution for this is to
immediately regenerate the filter.
Reprogramming:
Press + and – simultaneously for 5 seconds, the
red LED flashed 3 times for confirmation (if this
programming is not done, the program will be set
automatically after having switched on the device
10 times).
Deactivate the program:
Simultaneously press + and – for 5 sec. until the
third green LED flashes 3 times.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood. Never
use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel. The stainless
steel surfaces can be treated with Novy Inoxclea-
ner (906.060) after cleaning.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novy 7821 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novy 7821 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info