517649
21
Zoom out
Zoom in
Previous page
1/36
Next page
EN 21
With the halogen lights activated, dim by holding
button pressed.
A self restoring thermocontact switches the motor
off in case of overheating. The motor is ready for
use when cooled off sufficiently.
Ambient lighting
Press the on/off button for 3 seconds and the
ambiant lighting will start.
Programming the remote control
The remote control for hood and hob are pre-
installed and ready for use. Only when te remote
control needs to be reprogrammed (interaction
with other controls)act as in the following.
Determine the code used:
a. Simultaneously press
on/off + the key
with the sun. The lamp flashes as well as the
selected code (there are 10 code options in
total) (figure 1).
Change the code:
a. Simultaneously press
on/off + the
key with the sun for 3 seconds until the lamp
is flashing. After this the lamp as well as the
selected code will flash. Repeat this step until
you have reached the required code (there are
10 code options in total) (figure 1).
b. Simultaneously press
+ lamp of the roof
cover control until the second green LED is
blinking (figure 2).
c. Press the
key with the sun on the remote
control within 10 seconds to confirm the settings.
The cooker hood and the remote control are
now in line with each other (figure 3).
Change the batteries:
• For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the
new ones. Pay attention to the polarity marking
given in the battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in
as chemical waste.
NOVY key:
• You can switch on the ambient lighting using
the NOVY key (figure 5).
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
1 2 3 4 5
Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don’t reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook and
pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the monoblock filter
Only use the original Novy monoblock filter
(7300.055). After 200 cooking hours the filter
needs to be reactivated. To do so, place the filter
during one hour in an electrical oven on 120°C.
The filter can be reactivated 12 times. The hood
can be programmed so that a signal is given when
the 200 cooking hours are reached.
The monoblock filters are placed behind the
grease filter
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novy 7507 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novy 7507 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info