709180
9
Zoom out
Zoom in
Previous page
1/28
Next page
GB
Connecting the SOLAR-HOME-STATION Deleting all the programmed-in hand
AKKU-POWER-SYSTEM
Connecting plan (4) transmitter codes
Important instructions: - Press the “PRG” button on the SOLAR-HOME-
230V power supply for garage door operators with
- When connecting accumulators and charger STATION and keep it pressed for approx. 10
SOLAR-HOME-STATION SHS200
modules, it is important to observe the correct seconds until the LED starts flickering and then
polarity (fire hazard). goes out
Suitable for:
- When using operators with a protective
conductor connection, the SOLAR-HOME- Setting the operator
Novoferm
STATION must be properly earthed. To set the garage door operator, press the
NovoPort, Novomatic 403 / 553 / 553S and
- Follow all the instructions provided in the appropriate button on the hand transmitter. The
Novodoor
SOLAR-HOME-STATION'S Instruction Manual. SOLAR-HOME-STATION switches the 230V power
- Insert the operator's mains plug into the SOLAR- supply on. Program the operator in accordance
Siebau
HOME-STATION'S electric socket (4c). with the Operating and Installation Instructions.
ATS24, TYPE 403, TYPE 553, TYPE 553S,
- Connect the accumulator pack to the “AKKU”
TYPE 611
input of the SOLAR-HOME-STATION (4d). Attention: after 60 seconds the SOLAR-HOME-
- Do not connect the start cable until you have STATION automatically switches off the 230V
and
programmed the operator for operation of the power supply. Throughout programming, you
garage door (see point 5). The “START” output should therefore operate the hand transmitter
tormatic
on the SOLAR-HOME-STATION is connected to every 30 seconds to maintain the 230V power
GTA 601, GTA 602, GTA 611, GTA 612, GTA 701,
the “START“ input on the garage door operator supply until the process has been completed.
GTA 702, GTA 801 and GTA 802
using a two-core lead (4a, 4b and 4d).
- Connect the solar module (optional) to the Do not connect the start cable until all the
Becker / Rollmatic BV
“MODUL” input on the SOLAR-HOME- necessary settings have been made.
BOM 520, BOM 820
STATION.
Operation
If using operators of other makes, the switch-on
Use the hand transmitter to open and close the
behaviour can lead to malfunctions. Putting into service
door.
The SOLAR-HOME-STATION first switches on the
Charger For the remote control use a free channel on the
230V power supply.
Before being used for the first time, the hand transmitter. If no free channel is available,
After 2 ½ seconds, the station sends a start
accumulator pack must be charged. To do this, delete the transmitter that has been tuned into the
impulse to the operator.
connect the accumulator pack to the charger (1a). operator.
The door automatically travels to the end-of-travel
Plug the charger into the electric socket and set
position.
the slide switch to 12V (1b). The accumulator is Tuning the hand transmitter into the
After 60 seconds, the SOLAR-HOME-STATION
fully charged when the green light comes on. SOLAR-HOME-STATION
switches the 230V-power supply off again. The
Max. charging time 24 hours. - Press the PRG button on the SOLAR-HOME-
light on the operator goes out.
After charging, disconnect the charging cable STATION.
again (1c). - The LED on the SOLAR-HOME-STATION
Changing the accumulator:
flashes.
We recommend that you buy an additional
Installing the SOLAR-HOME-STATION and - Press one of the buttons on the hand transmitter
accumulator pack so that while one accumulator
the wall holder for the accumulator pack and keep it pressed.
pack is in operation, the other can be recharging.
Install the SOLAR-HOME-STATION within - As soon as the LED on the SOLAR-HOME-
accessible range of the operator's mains cable (0). STATION flashes rapidly, the hand transmitter
Change the accumulator as explained in 3a, 3b.
To do so, hold the station against the wall and has been tuned in.
Charge the accumulator pack as shown in section
mark the drill holes. Fix in place using suitable
1.
screws and wall plugs (2). Repeat the process for any further hand
Affix the wall holder for the accumulator pack transmitters. Up to 60 codes can be programmed
within accessible range of the SOLAR-HOME- in.
STATION using suitable screws and wall plugs (2).
1
2
4
5
Retain these installation, operating and maintenance instructions for the full duration of the operator’s service life!
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novoferm APS 230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novoferm APS 230 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Novoferm APS 230

Novoferm APS 230 Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info