709050

Novamatic by Hoover WT 1496 E Manual

9
Zoom out
Zoom in
Previous page
1/53
Next page
16
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
17
EN
Fix the sheet of corrugated
material on the bottom as
shown in picture.
Connect the fill hose
to the tap.
The appliance must be
connected to the water
mains using new hose-sets.
The old hose-sets should not
be reused.
The water-stop device
protects against water
damages caused by leaks
on the fill hose which could
develop due to natural
ageing of the hose.
In the water-stop system the
leaking water fills the
corrugated hose and
activates a stop valve which
cuts off the water supply to
the machine.
This fault is shown by a red
sector on the window «A».
Would this occur, please
refer to your Service Agent.
IMPORTANT:
DO NOT TURN THE TAP
ON AT THIS TIME.
Position the washing
machine next to the wall.
Hook the outlet tube to the
edge of the bath tub,
paying attention that there
are no bends or
contractions along the tube.
It is better to connect the
discharge hose to a fixed
outlet of a diameter greater
than that of the outlet tube
and at a height of min.50
cm.If is necessary to use the
plastic sleeve supplied.
The appliance must not be
installed behind a lockable
door, a sliding door or a door
with a hinge on the opposite
side to that of the washer
dryer.
Appliquer la feuille
supplémentaire sur le fond
comme dans la figure.
Raccorder le tuyau d’arrivée
d’eau au robinet.
L'appareil doit être relié à
l'arrivée d'eau exlusivement
avec les tuyaux fournis .
Ne pas réutiliser les anciens
tuyaux.
Le tuyau d’alimentation,doublé
d’une gaine,est équipé d’un
dispositif de blocage de l’eau.
Dans le cas où le tuyau se
détériorerait (usure naturelle ou
surpression), l’eau s’écoulerait
dans la gaine et actionnerait le
dispositif de blocage de l’eau
directement au robinet.
Cet incident serait alors signalé
par un témoin rouge situé dans
la petite fenêtre “A”.
Dans ce cas, fermez le robinet
d’eau et changez le tuyau.
ATTENTION:
NE PAS OUVRIR LE ROBINET
Approcher la machine contre le
mur en faisant attention à ce
que le tuyau n’ait ni coudes ni
étranglements.
Raccorder le tuyau de vidange
au rebord de la baignoire ou,
mieux encore,à un dispositif fixe
d’évacuation,hauteur mini. 50
cm,et de diamètre supérieur au
tuyau de la machine à laver.
En cas de besoin,utiliser le
coude rigide livré avec la
machine.
L’appareil ne doit pas être
installé derrière une porte
fermée à clef,une porte
coulissante ou une porte avec
une fermeture sur le côté
opposé à celui de l’appareil.
FR
IT
Applichi il foglio di polionda sul
fondo come mostrato in
figura.
Allacci il tubo dell’acqua al
rubinetto.
L’apparecchio deve essere
connesso alla rete idrica solo
con i nuovi tubi di carico forniti
in dotazione. I vecchi tubi di
carico non devono essere
riutilizzati.
Il tubo di carico dell’acqua è
provvisto di un dispositivo di
sicurezza che blocca l’afflusso
dell’acqua qualora il tubo di
carico si deteriori. Questo
fatto viene segnalato
dall’apparizione di una tacca
rossa nella finestrella “A”.
In questo caso il tubo di
carico acqua dovrà essere
necessariamente sostituito.
ATTENZIONE:
NON APRA IL RUBINETTO
Accosti la lavatrice al muro
facendo attenzione che non
vi siano curve o strozzature,
allacci il tubo di scarico al
bordo della vasca.
o meglio a uno scarico fisso;
altezza minima 50 cm, di
diametro superiore al tubo
della lavatrice.
In caso di necessità utilizzare
la curva rigida in dotazione.
L’apparecchio non deve
essere installato dietro una
porta richiudibile a chiave,
una porta scorrevole o una
porta con cerniera sul lato
opposto a quello della
lavasciuga.
DE
Befestigen Sie die gewellte
Bodenplatte wie in der
Abbildung dargestellt.
Den Zulaufschlauch an den
Wasserhahn anschließen.
Beim Anschließen des
Zulaufschlauchs ist die
Benutzung einer Rohrzange zu
vermeiden.Handfestes Ziehen
reicht völlig aus.
Das Gerät muß an die
Wasserversorgung mit neuen
Schläuchen angeschlossen
werden.
Alte Schläuche dürfen nicht
wiederverwendet werden.
Der Wasserzulaufschlauch ist
mit einem Wasserstop-System
ausgestattet.Sollte der
Innenschlauch durch
natürliche Alterung schadhaft
werden,so blockiert das
System die Wasserzufuhr zum
Gerät.Die Störung wird durch
das Erscheinen einer roten
Markierung im Fensterchen «A»
angezeigt.In diesem Fall muß
der Wasserhahn geschlossen
und der Schlauch ersetzt
werden.
ACHTUNG:
WASSERHAHN NOCH NICHT
ÖFFNEN.
Die Waschmaschine an die
Wand rücken,darauf achten,
daß dabei der Schlauch nicht
verkrümmt oder eingeengt
wird.
Ablaufschlauch am
Wannenrand
befestigen,oder an einem
festen Abfluß von mindestens
50 cm Höhe anbringen,dessen
Durchmesser größer ist als der
des
Waschmaschinenschlauchs.
Falls erforderlich den
mitgelieferten starren
Rohrbogen benutzen.
Das Gerät darf nicht hinter
einer verschließbaren Tür, einer
Schiebetür oder einer Tür
installiert werden,deren
Scharnier an der
gegenüberliegenden Seite wie
das des Gerätes ist.
Aplique la lamina de
polionda como se muestra
en la figura.
Conecte el tubo del agua
al grifo.
El aparato debe ser
conectado a la red
hidraulica sólo con los
nuevos tubos de carga
disponibles en dotación.
Los viejos tubos de carga no
tienen que ser reutilizados.
El tubo de alimentación
suministrado con la
lavadora tiene un doble
revestimiento e incorpora
una válvula para el agua.Si
se rompiera el tubo interno,
el agua se recuperaría en el
segundo tubo y la válvula
bloquearía
automáticamente el flujo
de agua para evitar fugas.
También se encendería el
piloto correspondiente.En
este caso hay que cerrar
inmediatamente la llave del
agua y solicitar al servicio
de asistencia técnica la
instalación de un tubo de
alimentación nuevo.
ATENCIÓN:
NO ABRA EL GRIFO.
Acerque la lavadora a la
pared procurando que no
se formen curvas o
estrangulamientos,fije el
tubo desagüe al borde de
la pila,o mejor aún,a un
desagüe fijo, con un
diámetro mayor que el del
tubo de la lavadora,a una
altura mínima de 50 cm.
En caso necesario, utilice la
curva rígida adjunta.
El aparato no debe ser
instalado detrás de de una
puerta que pueda ser
cerrada con llave,una
puerta corredera o una
puerta con bisagra en el
lado opuesto al de la
lavasecadora.
ES
Dispositif
antidévissage
(appuyer pour
devisser l’embout)
Dispositivo
antisvitamento
(premere per svitare la
ghiera)
Abschraubsperre
(muß gedrückt
werden,um den
Schlauch
abschrauben zu
können)
Dispositivo de cierre
(presionar para
destornillar la
abrazadera)
Safety antitwist device
(press and twist to
remove the washer)
➝
A
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Novamatic by Hoover WT 1496 E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Novamatic by Hoover WT 1496 E in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info