3
Parent unit
B1 On/Off button. . . . . . . . . . . . . . Switches power on or off
B2 Channel indicator. . . . . . . . . . . Shows the channel that has been set. Blinks when the unit is in
standby mode and remains on constantly when it is activated
B3 Low battery indicator . . . . . . . . Blinks when the battery is drained
B4 Range indicator . . . . . . . . . . . . Blinks if there is no contact with the baby unit
B5 Volume indicator . . . . . . . . . . . Blinks to show sound level when the unit is activated. Shows
the volume setting for two seconds when the unit is turned on
and remains on constantly when setting the volume
B6 ▼ button . . . . . . . . . . . . . . . . . Button for lower volume/programming
B7 M button. . . . . . . . . . . . . . . . . . Button for programming/storing
B8 ▲ button . . . . . . . . . . . . . . . . . Button for higher volume/programming
B9 Speaker
B10 Vibrator switch. . . . . . . . . . . . . Switches vibrator function on/off
11 Adapter contact
12 Switches to set digital code . . This is set at the factory, but you can set your own digital code
to avoid unnecessary interference. See detailed instructions
13 Battery pack contact
14 Belt clip
15 Battery compartment . . . . . . . Open to remove battery pack
16 Battery pack. . . . . . . . . . . . . . . NiMH rechargeable battery pack
17 Adapter
All warning sound signals from the parent unit are combined with a blinking symbol in one of the
units showing the cause of the alarm. The baby unit only gives a sound signal when turned on or
off, but not if the battery is weak. This means you can avoid waking the baby unnecessarily.
A warning that the baby unit batteries are weak is indicated by a blinking symbol on the baby unit
and a sound signal on the parent unit. If the parent unit emits a sound signal without any red lights
blinking, it is warning that the batteries in the baby unit are weak.
When out of range of the baby unit, the parent unit will indicate this with a sound signal and the
range indicator will blink. This is for safety reasons, as walls, particularly concrete walls, and
ceilings can significantly reduce the range. Metal plates (cars, motor homes) may block reception
of the signal. Relocating the baby unit and/or the parent unit may help because radio signals are
reflected from objects, people etc. This means there will be areas where no communication is
possible even if the range is short.
Detailed instructions
Setting the digital code
PrimaNOVA is equipped with a digital code
system DSIP (Digital Selectable Interference
Protection) with eight digital codes (1– 8).
The same code MUST be used on
both units! If the DSIP codes or the
set channel (A or B) are different
you will not hear a sound from the child,
and the units will indicate that they are not
communicating with each other!
The digital codes can be set using the switches
(12) in the battery compartment. Each unit has
three switches and the code is set according to
the following table.
Code Switch setting Code Switch setting
15
26
37
48
