TO USE AS SANDWICH MAKER
Wait until the plates are at the right temperature. Place a slice of bread on the lower plate, then the
filling, then another slice of bread. Close the appliance and clamp it shut. This is done by sliding
the catch on front to the left so that the U-shaped metal lip closes around the screw. The toasted
sandwich will be ready after about 3 minutes.You should use a wooden or plastic spatula to
remove the toasted sandwich in order to avoid damage to the non-stick coating.
TO USE AS A GRILL
In order to grill, heat the appliance while closed as it will heat much faster like this.
The cooking time will depend on the chosen dish or ingredients.You can, of course, experiment
with the cooking time to get the best results.
Small pieces of meat, fish etc. will be cooked through faster than large pieces.
Turn meat and fish once only in order to prevent them from drying out. For the same reason it is
better to use a spatula than to prick with a fork.
Use a wooden or plastic spatula on the frying plate. Do not use metal implements as these could
damage the non-stick coating.
CLEANING
ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING.
Clean the appliance after each time that you use it. Allow the appliance to cool completely first.
Clean the outside with a damp cloth. The plates can be cleaned using soapy water.You must rinse
them with tap water afterwards. The non-stick coating should not be cleaned with sharp metal
objects or aggressive detergents. If the plates are very dirty they should be soaked for half an hour
in hot water and detergent.
After grilling it is frequently only necessary to wipe the plates with kitchen paper while the
appliance is still warm.
DAMAGE TO THE PLATES CAUSED BY SHARP OBJECTS IS NOT COVERED BY THE
GUARANTEE!
NOVA ADVICE
• Place the grill on a sturdy and stable surface that is also heat-resistant.
• When you use the appliance in the open position the table or kitchen surface will become very
hot. For that reason, never put the open appliance on an unprotected plastic surface.
• Never immerse the appliance in water or any other liquid.
• The exterior of the appliance can become quite hot. Only pick up the appliance using the handle.
• Ensure that the appliance is not so close to the edge of the table or work surface that someone
could knock it off. Also, ensure that the cord is not trailing where someone could trip over it.
• Do not use the appliance if it is damaged or if the cable is damaged. Instead, send it to our
service department. With this type of appliance, a damaged cable should only be replaced by
our service department using special tools.
• Do not place the appliance on or directly adjacent to a warm hotplate or other source of heat.
• Always unplug the appliance before cleaning or if any fault develops.
• The plates become very hot; make sure that children do not come near it, and be careful
yourself as well.
• Do not use any abrasive cleaning materials.
• Only use the appliance according to the instructions.
• Do not use any accessories that are not recommended by the manufacturer.
• Keep the lead away from the plates.
7
