493107

Nova 320100 Manual

11
Zoom out
Zoom in
Previous page
1/35
Next page
8
Steam Station Basic Article 320100
4 Remove the rubber cap from the top of
the water reservoir.
5 Fill the water reservoir with the
indicated quantity of water (no higher
than the ‘max’ level).
6 Put the rubber cap back on the water
reservoir and close it tightly.
Use
• Never iron over zips, rivets in jeans,
etc. These will damage the soleplate.
Iron around any such objects.
• The steam generator’s holder for the
iron will become hot. Do not touch it
whilst you are ironing.
• Never point the soleplate at persons
during use, steam is very hot.
• Check whether ironing-instruction
labels are attached to clothing. Always
observe any such instructions.
• The filling aperture of the water
reservoir must not be opened during
use.
• Make sure that the appliance can not
fall when you place the iron on the
holder.
Dry ironing
1 Fill the water reservoir (No.6).
2 Put the iron on the steam generator’s
holder (No.5) and turn steam quantity
knob to "Min" position.
3 Put the plug in the wall socket.
4 Turn on the ON/OFF switch and turn the
iron's temperature-control dial (No.2) to
adjust the temperature to the required
setting. The iron starts heating.
5 Adjust the temperature in accordance
with the directions given in table 1.
6 When the indicator light on the iron
(No.1) turns off, the temperature is
reached. You now can start ironing.
Steam ironing
This steam iron has an energy saving
design for the steam function. This means
that the water is not heated up
continuously, but only when steam is really
needed. The flow system for the steam
requires therefore a warm up time of a few
seconds after pressing the steam button.
When the button is released the system
needs about 5 seconds to cool-down and
stop generating steam.
We advice to use the steam button as a
pulse button during ironing and press the
button short or long according the steam
need.
1 Fill the water reservoir. Make sure that
there is enough water in the water
reservoir.
2 Put the iron on the steam generator’s
holder.
3 Put the plug in the wall socket and turn
on the on/off switch.
4 Turn the temperature-control dial to
adjust the temperature to the required
setting. The iron starts heating.
5 Press the steam control button to pump
the water. The generator will heat the
water. Once the water has reached the
required temperature, the indicator light
“steam ready” will illuminate.
• During first use or reuse after a long
period, you should keep pressing the
steam control button for several
minutes to pump enough water into
the steam generator.
6 Adjust the quantity of steam to the
required level by turning the steam
quantity knob (No.8) to the desired
position.
7 Adjust the temperature by turning the
iron’s temperature-control dial to the
required setting. Adjust the temperature
in accordance with the directions given
in table 1.
8 The temperature indicator light on the
iron is illuminated whilst the iron is
heating up, and is extinguished once
the iron has reached the set
temperature. You can now start ironing.
9 Whilst you are ironing you can give a
shot of steam by pressing the iron’s
steam button.
1081656_nova_steam station_320100_V1.book Page 8 Tuesday, August 26, 2008 11:59 AM
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nova 320100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nova 320100 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info