557817
24
Zoom out
Zoom in
Previous page
1/35
Next page
NF/NM -4/8 Installatie en gebruikers handleiding
Isoleer en test functies
Version V0203
18 ISOLEER -EN TEST FUNCTIES
Er zijn mogelijkheden ingebouwd om zones en uitgangen
te testen of buiten dienst te stellen. Iedere individuele zone
kan buiten dienst of in test geplaatst worden. De uitgangen
transmissie, sirene en blussing kunnen enkel buiten dienst
gesteld worden. Er wordt verwezen naar deze isoleer en
test functies als de “Setup Mode”.
Buiten dienst - In deze mode zal de betreffende zone
niet meer reageren op zowel alarm als storingsmeldingen.
Deze toestand blijft behouden totdat deze handmatig
teruggesteld wordt.
Test - In deze mode kan men ieder element (detector of
handmelder) testen zonder dat men continu het systeem
moet resetten. De reset gebeurt dus automatisch na ieder
alarm. De sirene-uitgangen worden niet aangestuurd tenzij
er een optie via DIP schakelaar S2:sw1 en S2:sw4 wordt
ingesteld. Voor meer gegevens zie deel 19.1 In dat geval
worden de sirenes heel even gedurende 2 sec aangestuurd
samen met de buzzer om aan te geven dat het alarm
waargenomen werd.
Als het paneel in isoleer of test mode geplaatst wordt, dan
zal de buzzer niet aangestuurd worden. De transmissie
uitgang, algemene alarm en de blussturing worden niet
geactiveerd als er een alarm wordt waargenomen op een
zone die in test of buiten dienst staat.
Nota: Als er een alarm opkomt in een andere zone die
niet in test of buiten dienst staat, dan krijgt dit
onmiddellijk voorrang.
18.1 Procedure
Om in de setup mode te geraken volgen we onderstaande
procedure :
1. Breng de sleutel in en draai deze naar de midden positie
(TX UIT / TOETSEN AAN)
2. Druk op de CONFIG.(=stap) toets gedurende 3s totdat
de gele led TRANSMISSIE UIT / STORING snel begint
te knipperen
3. U bent dan in setup mode
Nota’s:
1. Als er geen acties gebeuren gedurende 20s dan
wordt de setup-mode automatisch afgesloten. Daarna
moet er opnieuw bovenstaande procedure gevolgd
worden.
2. In de setup mode zijn de transmissie en blussturing
automatisch buiten dienst geschakeld. De
bijhorende led’s geven dit dan ook aan.
STEP
NORMAL
DISABLE OUTPUTS/
ENABLE CONTROLS
POWER
HEALTHY
TD FAULT/
DISABLED
ES FAULT/
DISABLED
1 2 3 4 5 6 7 8
1
2
3
00:00:03
23
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Notifier NF8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Notifier NF8 in the language / languages: Dutch as an attachment in your email.

The manual is 2,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info