32
GB
The most typical case of clogging up in
the melting water outlet when you put
food wrapped in some paper into the
appliance and this paper contacts back
plate of the refrigerator and freezes to it. If
you remove the food right at this moment
the paper will tear and it can cause clog-
ging up in the outlet by getting into it.
So you are asked to be careful - because
of the
above - when placing foods wrapped in
paper into the appliance.
In case of increased demand e.g.
during heatwaves, the refrigerator
temporarily happens to operate constant-
ly. During this the automatic defrosting is
ineffective.
Remaining small ice and frost stains on
back plate of the refrigerator after defrost-
ing period is not abnormal.
exchanger. Information on your local dis-
posal sites may be obtained from your
municipal authorities.
The materials used on this appliance
marked with the sympol are recycla-
ble.
Maintenance
Defrosting
Bleeding part of the moisture of cooling
chambers in form of frost and ice goes
with the operation of the appliance.
Thick frost and ice has an insulating
effect, so it reduces cooling efficiency as
the temperature increases in the cooling
chambers and they need more energy.
At this type of appliance defrosting the
cooling plate of the refrigerator is auto-
matic without any external intervention.
The thermostatic control interrupts the
operation of compressor at regular inter-
vals for more or less time - during this
cooling is interrupted - the temperature of
the cooling plate goes above 0 °C due to
interior heating load of the compartment,
so defrosting occurs. When the surface
temperature of the cooling plate has
reached +3 - +4 °C the thermostatic con-
trol restarts operation of the system.
Melting water flows through defrost water
outlet leaded through the back into the
evaporative tray maintained on the top of
compressor and evaporates due to its
warmth.
Check and clean the outlet of
melting water coming during
defrosting regularly
- a label inside the appliance warns
you for this. If it is clogged the melting
water gathered can cause earlier fail-
ure as it can go to the insulating of the
appliance.
Clean the melting water outlet with the
supplied pipe scraper that can be seen in
the figure. The pipe scraper has to be
stored in the outlet.
