820675
15
Zoom out
Zoom in
Previous page
1/37
Next page
15
GB
7. The work lamp must be at
least 1 metre from the object
being lit.
8. The light source in the work lamp cannot
be replaced. When the light source has
worn out, the whole work lamp must be
replaced.
9. In the event of interference, the PIR
sensor may be aff ected, so the light
comes on even if there is no movement.
10. The glass is tempered. If the glass is
broken it will shatter into small pieces of
broken glass that are not dangerous to
humans.

1. Contact a qualifi ed person
before installation.
2. Switch off the power to the
relay before installation.
3. Connect the cable to the mains: blue
wire is neutral (N), brown wire is live (L),
and yellow/green wire is earth (PE).
4. Switch the power on again on the relay,
and check that the work lamp works.


When someone enters the sensor’s detection
range, the light is switched on automatically.
The light switches off automatically after the
set time, when there is no longer movement.
The sensor’s range, time alight and sensitivity
to light can be set as desired.

Set the sensors range (2–8 m).
A. If set to “MAX”, the range is 8 metres.
B. If set to “MIN”, the range is 2 metres.

Set the time alight (10 seconds to 10
minutes).
A. If set to “MAX”, the light is switched off
approximately 10 minutes after the last
registered movement).
B. If set to “MIN”, the light is switched off
approximately 10 seconds after the last
registered movement).

Sensitivity to light (5–2,000 LUX)
A. If set to “MAX”, the light is switched
on automatically, when movement is
detected within the sensors detection
range, whether it is day or night.
B. If set to “MIN”, the light is only switched
on at night, when movement is detected
within the sensors detection range.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nor-tec 70059 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nor-tec 70059 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info