801558
2
Zoom out
Zoom in
Previous page
1/2
Next page
Assembly
(2) To join the middle rod with the
upper and lower rods, open the
lever latches and engage the
pieces together. After adjusting
the length of the device to your
height, press the latches to
secure.
(1) After inserting the washers on
the lower shaft, place the lower
shaft in its location on the search
coil. Secure by tightening the
screw and nut. Do not
overtighten.
(3) Wind the search coil cable on
the shaft without stretching too
much. Then, plug the connector to
the search coil input socket on the
system box and secure by
tightening the nut. While
tightening, you may hear clicks
indicating that the connector is
secured.
(4) To adjust the armrest to your
comfort, push the red lock forward.
Adjust it by sliding it up or down
and secure by pushing the red lock
in the opposite direction. Insert the
armrest strap as shown in the
picture and adjust it to your arm
size and tighten.
Warning Icons
Low Battery Warning
Battery icon on the display shows the battery life status. When the
charge decreases, the bars inside the battery icon decrease, too.
When the battery is depleted, the battery icon will start flashing.
Check Coil
It indicates an interruption in the search coil transmitter signal. The
search coil connector may be unattached, loose or disconnected or the
search coil may have a defect. If the issue continues when you change
the search coil, there may be an issue in the coil control circuit.
Overload
Shallow and/or large targets may cause an overload and the device
starts to generate a continuous sound which resembles a siren.
Overload icon is shown on the display simultaneously. In such a
case, lift the search coil up until the icon disappears.
Software Update
Gold Finder 2000 has software update capability. All software updates made
after the device is released to the market will be announced on the product's
web page along with updating instructions.
WARRANTY
This product has a 2 year limited warranty from the time of purchase. Please
refer to www.noktadetectors.com for further warranty information.
Factory Defaults
Press and hold the M button immediately after turning on the device.
When the display light turns on, release the M button. The bar will rise and fall,
the battery icon will fill up and the device will revert back to factory defaults.
Changing the Wireless Connection Channel
To change the channel, press and hold the M button for 3 seconds while
the device is on. The frame around the search modes icon will start blinking.
Change the frequency using the volume +/- buttons.
The channel number will be reflected on the right side of the bar. The right
side of the bar will start filling up / falling each time you press the sensitivity
+/- buttons. There are a total of 20 channels. When the bar is completely
empty, it means that the wireless connection is off.
Wireless Connection
Gold Finder 2000 has a built-in wireless module which allows for wireless
speaker and wireless headphones connection. The wireless speaker is
supplied with the device and the pairing instructions are provided below. You
can find the pairing instructions for the wireless headphones in the Nokta
Makro 2.4GHz Wireless Headphones sold separately.
Turn on the wireless speaker by pressing and holding down the power button
and do not let go of the button until the beep indicating the battery status is
heard. The green LED on the speaker will start flashing fast. The speaker is
ready to be paired with the device. Turn on the device while pressing the
sensitivity plus (+) button. Do not let go of the sensitivity plus (+) button until
the device is turned on and the wireless icon appears at the center
bottom of the screen. Once the wireless icon is displayed, the sound will be
heard both from the device and the speaker.
If the pairing is not successful, repeat the above steps.
FCC STATEMENT
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
For Consumers within the European Union: Do not dispose of this
equipment in general household waste. The crossed wheeled bin
symbol on this equipment indicates this unit should not be
disposed of in general household waste, but recycled in compliance
with local government regulations and environmental requirements.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nokta Makro Gold Finder 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nokta Makro Gold Finder 2000 in the language / languages: English as an attachment in your email.

The manual is 1.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nokta Makro Gold Finder 2000

Nokta Makro Gold Finder 2000 Quick start guide - German - 2 pages

Nokta Makro Gold Finder 2000 Quick start guide - Dutch - 2 pages

Nokta Makro Gold Finder 2000 Quick start guide - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info