774465
32
Zoom out
Zoom in
Previous page
1/38
Next page
Clean the interior and exterior of the case with a soft, damp cloth without cleaning agents only.
Empty the drip pan (picture 1/N) and the used coffee tray (picture 1/O) when the display shows
itat the latest (only when the device is switched on, because the device only then recognises that
the bowls have been emptied).
Information: Occasionally, use some soap water for cleaning the drip pan (picture 1/N).
The water tank should be rinsed with clear water daily and refilled with fresh, cool water.
Information: Dried milk residues are hard to remove.
Therefore, clean the milk frother, tube and outlet regularly.
Information: From time to time (ideally prior to a longer break in preparation, but definitely regularly!)
the milk frother has to be dismantled completely into individual parts and cleaned under clear water.
Pull the milk frother downwards (picture 10/11) and dismantle it into its individual parts (picture
1/R).
Clean the individual parts (picture 1/R) thoroughly and assemble the milk frother again.
Insert the assembled milk frother upwards onto the steam tube up to the stop (picture 10/11).
Information: Your appliance is fitted with rear rolls (picture 1/Q) (only designs 670, 675, 680). These
enable the movement on even working surfaces. That, you can also clean underneath the appliance.
5.7. Cleaning of the brewing unit
Warning: Only remove the brewing unit when the appliance is turned off.
Warning: Clean the brewing unit after a carried out cleaning programme for example, but at least once
a month. Otherwise the guarantee claims may expire.
If required, the brewing unit should be taken out and cleaned under running water. Do not use
cleaning agents under any circumstances but only clear, clod water! For hygiene reasons we recommend
to take out the brewing unit i.e. after a carried out cleaning programme (see point 5.4.) and to clean
it thoroughly.
Open the service door on the case on the right (picture 1/L) by slightly pulling the unlocking
device in the handle to you and slowly removing the service door of the appliance's case.
Unlock the brewing unit by pressing the red switch upwards and to turn the handle to the left up
to the stop and click (picture 12).
Then, carefully remove the brewing unit with the handle.
Clean the brewing unit under cold water and leave to dry.
Carefully insert the brewing unit again and lock it by holding the red switch down and by turning
the handle to the right up to the stop and click.
Close the service door again, in doing so, guide the pins at the rear end of the service door into
the gaps. Then, shut the service door (picture 1/L) until it clicks.
5.8. Change lter
After the ow of approximately 50 l of water, the effect of the lter is exhausted. The display shows
“CHANGE FILTER’’.
You can still prepare beverages. However, we recommend to always change the lter immediately.
Turn the rotary to “SETTINGS’’. Press the rotary.
Turn the rotary to “FILTER’’. Press the rotary.
30
5. Cleaning and care
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nivona NICR675 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nivona NICR675 in the language / languages: English as an attachment in your email.

The manual is 7.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nivona NICR675

Nivona NICR675 User Manual - German - 38 pages

Nivona NICR675 User Manual - Dutch - 38 pages

Nivona NICR675 User Manual - French - 39 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info