49
➔ Press the program key P to enter
programming mode.
➔ Press the > key until “SELECT
CLEANING” appears.
➔ Press the ‘ok’ key. The display
reads “MANUAL CLEANING”
➔ Press the ok key. “EMPTY TRAYS”
appears alternately with “FILL
WATER” in the display.
➔ Continue as described above, from
Point 5.3, ‘Remove the drip tray …
5.4 Descaling
Note: When the machine needs des-
caling, the message “PLEASE DES-
CALE” appears in the display and the
service button (fig. 1/I) flashes.
However, you can start the descaling
program manually at any time (see
under ‘Descaling manually’).
Tip: Only press the service button
when you wish to start the des caling
program. Please strictly ob serve the
order of the following instructions
when descaling your machine. You can
continue to make coffee, hot water or
steam, but we do recommend that
you complete the descaling program
as soon as possible.
Caution: Once started, the descal ing
program cannot be interrupt ed. Never
use vinegar or acetic acid based
agents for descaling. Use standard
liquid products avail able in specialist
retailers and recommended for use on
fully automatic coffee centres.
Caution: Make sure to take the
filter out the machine for descaling
when instructed to do so.
➔ Press the service button (fig. 1/I).
The display reads “EMPTY TRAYS”.
➔ Empty the drip tray (fig. 1/Z) and
replace it in the machine. The display
reads “REMOVE TANK”.
➔ Remove the water reservoir (fig. 1/B
and 2) – the display reads “FILL
WATER / DESCALER IN TANK”. Fill
tank with water up to the 0.5 l mark
before adding the descaling agent.
(Caution: never the other way round –
consult the manufacturers’ instruct -
ions).
➔ Replace the water reservoir in the
machine. The display reads “TURN
VALVE”.
Tip: Place a fairly large container
(about 0.5 l) under the coffee spout
(fig. 1/J and 5) and under the steam /
hot water jet (fig. 1/T and 8).
➔ Open the steam / hot water valve
(fig. 1/Q and 7) by turning the control
knob to the right.
➔ The machine descales auto matic al-
ly and the descaling so lution now
flows out at intervals through the steam
/ hot water jet (about 10 mins.).
➔ Wait for the next instruction in the
display, “TURN VALVE”, then turn the
valve control knob (fig. 1/Q and 7)
back to the left.
➔ The descaling solution now flows
out at intervals through the inside
spout (about 15 mins.).
➔ Please wait for the next in struct ion
in the display, “EMPTY TRAYS”.
➔ Remove and empty the drip tray
(fig. 1/Z). The display reads “FILL
WATER”.
➔ Fill the reservoir with fresh water
and replace it and the drip tray in the
machine. The display reads “TURN
VALVE”.
➔ Open the steam / hot water valve
(fig. 1/Q and 7) by turning the control
knob to the right.
... 5. Maintenance and Care
