22
5.3 Cleaning program
When the machine needs to be
cleaned, “PLEASE CLEAN” ap -
pears in the display and the
service button (fig. 1/I) flashes.
Tip: Only press the service button
(fig. 1/I) when you wish to start
the cleaning program. You can
continue to make coffee, hot water
or steam. However, we recommend
that you start the cleaning program
as soon as possible.
Caution: Once running, the clean -
ing program must not be inter -
rupted. Only add cleaning tablet
when the machine instructs you to.
➔ Press the service button (fig. 1/I).
The display reads “EMPTY TRAYS”
alternately with “FILL WATER”.
➔ Remove the drip tray and used
coffee tray (fig. 1/W and 1/U) and
clean them both.
➔ Fill the reservoir (fig. 1/B and
2) with fresh water and replace it
and the tray (fig. 1/W) in the
machine.
➔ The machine rinses briefly and
the display shows “CLEANING
TAB. INTO / POWDER SHAFT”.
Tip: Place a sufficiently large con-
tainer (about 0.5 l) under the cof-
fee spout (fig. 1/J and 5).
➔ Put a cleaning tablet into the
ground coffee chamber (fig. 1/O)
and shut the lid. The display reads
“PRESS S KEY”.
➔ Press the service button (fig. 1/I).
➔ The machine starts the cleaning
operation.
➔ The cleaning operation runs
automatically and lasts about
10 minutes. As soon as the cycle
is complete, the display shows
“EMPTY TRAYS”.
➔ Empty, clean and replace the
drip tray (fig. 1/W).
➔ Fill up the water reservoir (fig.
1/B and 2) again with fresh water
if required.
➔ The machine warms up briefly
and is then immediately oper -
ational.
Manual cleaning
If required, the cleaning program
can also be started even if no
indication has been displayed by
the machine that this is necessary:
➔ Press the program key ‘P’ to
enter programming mode.
... 5. Maintenance and Care
