16
4. Programming functions
The following buttons are used for
programming functions:
Service button ‘S’ = programming
mode / confirmation button
(fig. 1/I)
Coffee strength button = Selection
button (fig. 1/E)
On / Off button = cancel (fig. 1/F)
Important: Note that functions can
only be programmed when the On /
Off button (fig. 1/F) is switched to
‘Off’ (stand-by mode).
You can program / re-program the
following functions:
Operation with / without filter =
‘Change filter’ (Symbol 20)
Water hardness = ‘Descale
machine’ (Symbol 18)
Temperature = ‘Coffee ready’
(Symbol 8)
Automatic stand-by = ‘Water /
steam open / closed’ (Symbol 16)
4.1 Filter
Inserting filter:
A special filter for the water reser-
voir is included in the machine
accessories. If you use this filter
correctly you will not need to des-
cale your coffee machine as often
(recommended: about twice yearly,
see point 5.4, ‘descaling’). So that
the machine knows that the filter
has been inserted, you must
change the filter setting to ‘On’.
The default setting is ‘without
filter’.
The current setting is designated
by the following symbols:
· Function setting for filter ON:
Symbols 14 and 9 light up
· Function setting for filter OFF:
Symbol 14 alone lights up.
➔ Switch your machine off (stand-
by mode) by pressing the On / Off
button (fig. 1/F).
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to enter programming mode.
➔ Symbols 20, 18, 8 and 16 light
up and rotate sequentially in the
display.
➔ Wait until the filter symbol
(Symbol 20) lights up and press
the Selection button (fig. 1/E and
6).
➔ Symbol 14 starts to flash.
➔ Press the Selection button (fig.
1/E and 6) until both Symbols 14
and 9 (‘filter ON’) flash.
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to confirm. Symbols 13, 16 and
20 flash.
